User manual JBSYSTEMS LIGHT TUBELED CONTROLLER V 1.1

[. . . ] Don't use near strong magnetic fields and objects carrying high voltages. The electrical installation should be carried out by qualified personal. We strongly suggest NOT opening the unit, there are no user serviceable parts inside. In the event of serious operating p7roblems, stop using the unit and contact your dealer immediately. [. . . ] Don't connect the unit to any dimmer pack. Always use an appropriate and certified safety cable when installing the unit. In order to prevent electric shock, do not open the cover. never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, derigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. [. . . ] GROUND CONNECTION: Use this connection to ground the led tubes properly. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Test each tube independently before installing: just connect each tube separately to the mains voltage (no signal cables connected!) the tube is OK when it lights up in white color. [. . . ]