User manual JBSYSTEMS LIGHT TWINBEAM COLOR V 1.0

[. . . ] Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. This product meets the requirements of the current European and national guidelines. [. . . ] This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Laser Light is different from any other light source with which you may be familiar. The light from this product can potentially cause eye injury if not set up and used properly. Laser light is thousands of times more concentrated than light from any other kind of light source. This concentration of light power can cause instant eye injuries, primarily by burning the retina (the light sensitive portion at the back of the eye). Even if you cannot feel "heat" from a laser beam, it can still potentially injure or blind you or your audience. Even very small amounts of laser light are potentially hazardous even at long distances. Never look into the laser aperture or laser beams Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. the parent document and cornerstone of laser safety standards ANSI Z136. 1 (2007) provides guidance for the safe use of lasers and laser systems by defining control measures for each of the four laser classes. This valuable document can be obtained from www. Org Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!Use the keys to make sure only a skilled operator is able to switch the laser on. INTERLOCK input: used to connect the optional emergency stop switch (see picture). When you push this switch the laser beam will disappear immediately. For your own safety we strongly recommend to connect this optional switch!INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. This input receives instructions from a DMX-controller. [. . . ] Do not switch the unit on and off in short time intervals as this reduces the lamp life. Always unplug the unit when it is not used for a longer time. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Important: Never look directly into the laser beam! [. . . ]