User manual JBSYSTEMS LIGHT X-310

[. . . ] If moisture, water, or fog liquid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. Refer to your ANTARI dealer or other qualified service personnel. Never leave the unit running unattended. Avoid coming within 60 cm of the output nozzle during operation. [. . . ] For further information on operating your ANTARI X Fazer, see the section titled, "Control Module Operation" on page 4. Caution: "Visibility during operation is reduced" If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of inclination. Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit. If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, control module connection, and power from the wall. If fog does not come out after holding the control module button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the control module button, as this may damage the unit. Return the machine to your ANTARI dealer immediately. Its LCD displays current operating parameters, which are automatically stored in non-volatile memory, allowing the machine to be powered down without losing function settings. Via the Function key, you can adjust the desired settings. Pressing the Function key will cycle through different options including Volume, Timer, Heat & Fan. the Enter (Volume) Key is used to select the desired option. To adjust fog output volume setting, simply go into Volume option. Use Enter (Volume) Key to select each option and make changes as desired. To turn off the heater and fan, go into Heat & Fan option. use Enter (Volume) Key to confirm the selection. Always press Enter(Volume) key to confirm setting. Press ESC(Timer) key to exit current menu level and move to an upper(previous) level. The display shows the adjusted interval and the device counts the seconds down to "0". If you wish to deactivate the timer function, press the Timer key once more. [. . . ] For quiet operation, lower down Fan output as desired. All fog machines have a recycling period after long bursts when the machine will shut itself down for a short period in order to heat up again. During this time, no fog can be produced. Please read and save these instructions Warrants to the original purchaser that the ANTARI X Fazer will be free from original defects in workmanship and material for a period of six months from the date of purchase. [. . . ]