User manual JBSYSTEMS LIGHT Z 1200II

[. . . ] If moisture, water, or fog fluid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. Refer to your ANTARI dealer or other qualified service personnel. For adult use only and must be installed out of the reach of children. Never leave the unit running Avoid coming within 60 cm of the output nozzle during operation. [. . . ] The shipping carton should contain the following items: 1. One unit of Z-1200II Fog Machine Power cord Z-8 multi-function remote control with attached cord User Manual Model Number Power Supply Power Consumption Output Volume Tank Capacity Fluid Consumption Weight Dimensions(mm) Remote Included Z-1200II AC100-120V, AC220-240V / 50HZ-60HZ 1250 W ca. Remote Control Operation Z-8: 10 meter wired multi-function remote control with 5-PIN plug for ANTARI Fog Machine model Z-1200II. The Interval knob adjusts the time between discharges when the timer function is engaged. The range is from 10 seconds to 250 seconds. When activated, the yellow light will turn ON. The volume can be adjusted using the volume knob to control the amount of fog produced. The volume knob can be used to regulate the volume of the steady stream of fog produced. The green MANUAL button will produce a continuous blast at maximum volume while the button is held down. When released, the manual function stops and the machine will return to the previous setting; timer, continuous, or stationary. note: The continuous function will override the Timer function. Therefore, if both buttons have been depressed the Z-1200II will fog continuously. the manual function overrides all functions. When depressed and held down the Z-1200II will fog at maximum volume for as long as the button is held down, regardless of the machine's setting at the time. If any equipment is missing contact your ANTARI dealer immediately. Before beginning your initial setup on ANTARI Z-1200II Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any other types of fluid can damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid tank. Firmly attach the Z-8 remote control cable to the proper input on the back of the machine. Plug the remote control cord into the slot marked remote control on the back of the machine. [. . . ] If Channel A has a value from 0 to 5, the unit is OFF. When storing run distilled water (not tap water) through the system as described in the cleaning regimen above. This will help avoid any particles condensing inside the pump or heater. Please read and save these instructions. [. . . ]