User manual JBSYSTEMS LED FLOWER DMX V2.0

[. . . ] If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Standard flammable surfaces include building materials such as wood and wood-based materials more than 2mm thick. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!This appliance must be earthed to in order comply with safety regulations. never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!The installations should be inspected every year by a skilled person to be sure that safety is still optimal. If you don't like a messy installation with a lot of DMX cables hanging everywhere, just hide them inside the LED bar!To do this, just follow these steps: 2: Disconnect the earth conductor cable from the frame by removing its bolt and nut with a pincer. ALUMINIUM BODY: The aluminium enclosure is equipped with a sliding mechanism on both sides: BOTTOM SIDE: Use the 4 bolts/nuts (2) to attach the PAR projectors. uPPER SIDE: Can be used to attach 2 (optional) clamps for installation under truss. In this case you should also use the included lifting eye bolt to secure the LED 4Bar with a suitable safety cable (optional). SLIDING BOLTS/NUTS: used to fix the projectors to the LED 4Bar. 35mm STAND ADAPTER: used to put the LED 4Bar easily on top of a light stand 4. 4A DMX-INPUT: used to connect the LED 4Bar to the DMX-output of the previous unit in the DMXchain. DMX-connectors 4A and 4B are connected inside the LED 4Bar. 4B DMX-OUT TO PROJECTOR1: use a standard premade DMX-cable to connect connector 4B to the DMX-input of the first LED projector. [. . . ] When the problem is solved, simply push the button to reset the circuit breaker. END CAP: To install the bolts/nuts (needed to fix the projectors) and stand adapter you have to remove this end cap on one side of the unit: simply unscrew the 4 screws remove the cap put the nuts/bolts and/or stand adapter in the sliding rail put the cap back in place fix the 4 screws done! 3: Slide the front panel gently out of the frame so that you can take out the strain reliefs. 4: Gently tear out the strain reliefs and remove the small piece of "dummy" cable that we installed. [. . . ]