User manual JBSYSTEMS SMX.1 V1.2

[. . . ] Reproduction or publication of the content, even portions, in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Congratulations and thank you for buying this SYNQ® product. Please read these operating instructions carefully so you will know how to operate this product properly. [. . . ] It can be adapted with the "preset" buttons (24) and/or the "time parameter knob"(33). ROLL EFFECT: This effect can be used in FADER and AUTO mode: FADER MODE: Press the Roll effect button and move the cross fader from one end to the other. If you want the automatic beat Counter to take over again, simply push for some seconds on the TAP button until it stops flashing. PRESET BUTTONS: These buttons are used as presets for the different effects. Depending on the selected effect, these presets can be settings related to the beat, filter frequencies, percentage of pitch change, etc. Each button has one of the following inscriptions: 2 ­ 4 ­ 8 ­ 16 ­ 32. These digits are related to the measured beat. Once the preset is selected, it lights up. You can also select the additional presets by pushing the "time parameter knob" (33) while you select the presets 4 ­ 8 or 16. In that case the preset button starts flashing to indicate that the indication above the button (1/4 ­ ½ or 1/1) is selected. It's good to know that the presets are preserved when you change to another effect. Example: if the "echo" effect is selected and you choose for preset "2", you will notice that the sound is repeated every 2 beats. If you choose "4", the sound repeats every 4 beats. Select the ½-preset if you want the music to be repeated every half beat. When the beat counter is unable to count the beats, the BPM display starts flashing until the BPM counter is able to continue. TIME (X) PARAMETER: for certain effects the display shows time information (mSec) for other effects the display shows percents (%) or cutoff frequencies (kHz). You can change these parameters with the preset buttons (24) and with the "time parameter knob"(33) if you need fine tuning. CUE BPM / DEPTH (Y) PARAMETER DISPLAY: Displays the BPM value for the cue signals coming from one of the 4 input channels, (CH-1 to CH-4) selected using one of the CUE-buttons (39). When you adjust the depth (Y) parameter knob(32), the new value will be displayed (%). EFFECTS DISPLAY: Shows which effect you selected. EFFECTS INPUT DISPLAY: Shows which signal you selected using the "input select knob"(30). INPUT SELECT KNOB: Used to select which signal goes to the input of the effects unit. [. . . ] Remove the 2 screws that keep the cross fader in place. Gently remove the fader and the cover plate from their position. Unplug the cross fader from the cable (unplug the cable by pulling the connector, NOT the cable! ) Press the new cross fader on the cable. [. . . ]