User manual JBSYSTEMS SPACE LASER 3 V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To protect the environment, please try to recycle the packing material as much as Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. This input receives instructions from a DMX-controller. DMX OUTPUT: 3pin female XLR-connector used to connect the Space 3 laser with the next unit in the DMX chain. DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Apart from DMX-mode you can also select 4 other modes, see further for these different operation modes. CONTROL PANEL: Used to control the different functions of the laser, see further to learn how to operate the unit. REMOTE CONTROLLER INPUT: Input for the CA-8 remote hand controller, see further for more information on this issue. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. Turn the potentiometer until the laser works in sync with the music. COOLING FAN: used to cool the components inside the enclosure. Make sure to never cover this fan outlet!We suggest to take off the plastic cover from time to time to clean the dust filter inside. Don't operate the unit without the dust filter installed: dust will enter the enclosure and disturb the operation of the laser. SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure; make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. Use the keys to make sure only a skilled operator is able to switch the laser on. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience! [. . . ] Do not switch the unit on and off in short time intervals as this reduces the lamp life. Always unplug the unit when it is not used for a longer time. or before replacing the bulb or start servicing. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. [. . . ]