User manual JBSYSTEMS STORMBIRD V1.0

[. . . ] Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. ⷠKeep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. [. . . ] If a foreign object enters the unit, immediately disconnect the mains power. ⷠLocate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. ⷠDon't cover any ventilation openings as this may result in overheating. ⷠPrevent use in dusty environments and clean the unit regularly. ⷠKeep the unit away from children. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Use the small knob on top of the effect to adjust the focus of the gobos: · Loosen the knob a little until you can move it forward and backward. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Wait for about 10 minutes until the unit has been cooled down. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. [. . . ] ⷠIn order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. ⷠThe interior of the device should be cleaned annually using a vacuum cleaner or air-jet. ⷠThe cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. [. . . ]