User manual JENSEN VOYAGER AWM930

[. . . ] IMPORTANT NOTES *Avoid installing the unit in locations described below: - Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters - On top of other stereo equipment that radiates too much heat - Places lacking ventilation or dusty places - Humid or moist places *Read Owner's Manual before operating *Be sure all connections are properly made before turning power on. IDENTIFICATION OF CONTROLS / CONNECTIONS 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) 19) 20) 21) 22) 23) Tuning Up / Track Up / Seek / Minute Set Button Tuning Down / Track Down / Seek / Hour Set Button Mute / AS/PS / Loud Buttons Time Set Button Display Window Alarm Set / Alarm On/Off Buttons Button Reset Preset / Repeat Button Preset / Shuffle Button Preset / Scan Button Preset Buttons CD Player CD Eject Button Speaker Selector 1/8" Auxiliary Input Jack Stereo Headphone Jack Audio Adjust Button Power Switch with Volume Control Source Selectors Car Antenna FM Antenna Terminals RCA Auxiliary Input Terminals Harness 1 INSTALLATION AND HOOK UP 1) Cut mounting hole in desired location using mounting hole diagram (right) 2) Route power, speaker, and antenna cables through hole, and connect to unit as shown in hook up diagram below. 3) After making sure connections are correct, test unit operation as described in the operation section (Do not mount until AM antenna trimmer adjustment has been made. WIRING COLOR CODE FOR AWM-930 COLOR FUNCTION ORANGE/WHITE +12VDC IGNITION POWER GREEN/WHITE +12VDC BATTERY POWER TO CHASSIS GROUND BLACK/WHITE WHITE LEFT (A) SPEAKER (+) VIOLET LEFT (A) SPEAKER (-) BLUE RIGHT (A) SPEAKER (+) GREEN RIGHT (A) SPEAKER (-) RED LEFT (B) SPEAKER (+) VIOLET/BLACK LEFT (B) SPEAKER (-) YELLOW RIGHT (B) SPEAKER (+) RIGHT (B) SPEAKER (-) GREEN/BLACK NOTES: - Speakers must have a minimum of four impedance each. [. . . ] 2) Use the Source Selectors (19), to select the CD button. 3) Use the Speaker Selector Switch (14) to choose between speaker output, headphones, or both. 4) Press the CD Eject button (13) to eject any CD's that may already be in the player. 5) Insert an audio CD into the CD player (12). 6) Press the CD Play / Pause button (the same as the CD Source Select button). 7) You may change tracks by using the Track Up or Track Down buttons (1 or 2). 8) To eject the CD, press the CD Eject button (13). 3 CD CONTROL BUTTONS The RPT button (8) repeats the current track The SHF button (9) randomly shuffles the tracks. The SCN button (10) scans the first 5 seconds of each track. Note: Power can be turned on by pushing any button on the front of the AWM930. AUXILIARY INPUT 1) Push Power Switch (18) "on". 2) Using the Source Selectors (19), choose the button labeled "AUX". CD shuttle) connected to the Auxiliary In Jacks (22) on the rear of the radio, then you can listen to your external source through the system. 4) An external auxiliary source can also be used (such as a portable cassette player) through the 1/8" Auxiliary Stereo Input Jack (15) on the front of the radio. SETTING THE CLOCK 1) Push the Power Switch (18) "on". [. . . ] 2) Pressing this button for longer than 2 seconds will activate the Auto-store Tuning feature which will automatically scan the band and enter up to 6 strong stations into the 6 pre-set memories (the indication "AST" will flash on the display to show that Auto-store Tuning is in progress). After entering the stations into the memories, the unit will automatically stop at each station for approx. [. . . ]