User manual JENSEN VOYAGER JE1909ACB

[. . . ] - Do not operate this unit with only one speaker hooked up. If a speaker fails, replace it before operating this unit. NOTE: Always be sure when running cables to avoid sharp edges, extreme heat sources, and any other potential hazards. 2 OPERATING INSTRUCTIONS NOTE: Number in parenthesis (#) corresponds with "Identification of Controls / Connections" on page 1 of this manual. LIQUID CRYSTAL DISPLAY PANEL The liquid crystal display (LCD) panel displays the frequency, time, and activated functions. [. . . ] In addition, the visibility on the numbers of the LCD may slightly decrease. The LCD read out will return to normal when the temperature increases to a normal range. TUNER 1) Turn power on by pushing the Power Switch Control Button (18). 2) Use the Source Selectors (19), select the AM /FM button. 3) Use the Speaker Selector Switch (14) to choose between speaker output, headphones, or both. 4) Use Tuning Up (1) or Down (2) buttons to select the station manually. Also, the Station Preset buttons can select stations (this will be discussed later in the manual). Push either of the Seek buttons (1 or 2) to tune to the next higher or lower active station. 5) Adjust Volume Control (18) to suit taste. Note: The T/ F also toggles between time and radio frequency on the display. SETTING STATIONS INTO MEMORY PRESET 1) This unit has the ability to set 18 FM and 12 AM stations into memory. 2) To set the AM or FM stations into memory, first tune to the desired station. 3) Once at the desired station, press and hold preset button (8, 9, 10, or 11) you wish to program for more than 3 seconds. 4 USING THE AUDIO ADJUST BUTTON 1) You can toggle between volume, treble, bass, and balance control by pressing the Audio Adjust button (17). 2) Once at the desired function, you can use the volume knob to adjust. SETTING THE ALARM 1) Hold the Alarm Set button (6). 2) Use the H and M buttons (1 and 2) to adjust hours and minutes. 3) The Alarm On /Off button (6) activates or deactivates the alarm. BEEP FEATURE 1) Hold the Audio Adjust button to enable the beep feature (17). Lower right side will display an audio symbol when this feature is turned on. 2) When this feature is on, turning different features on or off will produce two different tones, higher tone for ON, and lower tone for OFF. [. . . ] 3) Completely removing power from the unit will turn the beep feature off. AS/PS BUTTON This button is for Auto-Store Tuning (AS) and Pre-set Scan Tuning (PS) (3) 1) Press this button momentarily during radio operation to scan the stations pre-set into the memories of that band. The unit will stop at each pre-set station for approx. [. . . ]