User manual JENSEN VOYAGER JHDHBMT INSTALLATION

[. . . ] JHDHBMT Installation Instructions INSTALL MOUNT TO HANDLE BAR 1. Remove the 2 Clamp Bolts, using the supplied 5/32" hex key, separate the clamp and place the bottom half under the handlebar where you want to locate the mount on the handlebar. Place the top half of the clamp on the handlebar and install the Clamp Bolts. [. . . ] To move or adjust the angle again, the Black Set Screw must be loosened. BASE PIVOT: The Base Pivot can be turned to any direction needed. Remove the Shaft Bolt holding the Shaft onto the Base Pivot using the supplied 3/16" hex key. This allows access to the 1/8" Base Pivot Bolt inside the Base Pivot. Loosen the Base Pivot Bolt using the supplied 1/8" hex key enough to lift the Base Pivot and clear the locking pin on the top of the clamp. Turn to the desired location and make sure that the locking pin is in one of the locking holes on the bottom of the Base Pivot before tightening the Base Pivot Bolt. MOUNT RADIO: At this point you should be able to decide the position of the Top Plate. Once you are satisfied that you have positioned the mount exactly where you want it, it is time to mount the JHD MINI radio. Using the 4 M4 machine screws that were included with the JHD MINI radio, attach the radio to the Top Plate matching up the 4 holes on the back of the radio to the 4 holes on the top Plate (AMPS Pattern). 37200045 REV-B HANDLEBAR MOUNT PART #JHDHBMT INCLUDES: (1) (1) (1) (1) (1) JHDHBMT 3/16" Hex Key 5/32" Hex Key 1/8" Hex Key 7/8" Reducer Bushing LIMITED WARRANTY DISCLAIMER: High Gear Specialties, Inc. ("High Gear") warrants the Techmounts (the "Mount"), as described and identified in the accompanying installation instructions, to be free from defects in material and workmanship for a period of one (1) year from purchase (the "Warranty Period"). All warranty claims by the customer shall be made to High Gear Specialties, Inc. , 940 W. Oakland Avenue, Suite A10, Oakland, FL 34787. Replacements shall not interrupt or prolong the term of this Warranty. High Gear's obligation under this Warranty is limited, at its sole and exclusive option, to either the repair or replacement of the Mount where a defect has been claimed during the Warranty Period, and which is returned, freight prepaid, to High Gear at the address given above. Upon inspection by High Gear, the Mount or parts thereof which prove to be defective will be repaired or replaced at no charge. THE WARRANTY SET FORTH ABOVE IS EXCLUSIVE AND NO OTHER WARRANTY, WHETHER WRITTEN OR ORAL, IS EXPRESSED OR IMPLIED. [. . . ] We strongly recommend that you closely follow the accompanying installation instructions and employ good judgment in your use of the mount. Do not allow yourself to become distracted by whatever equipment or other item is secured by the mount when you are riding. Always wear a helmet, proper eyewear and protective clothing when riding, and never ride when under the influence of alcohol or drugs. [. . . ]