User manual JENSEN VOYAGER PADIN3

[. . . ] We've tried to make the instructions in this owner's manual clear and easy to follow. If you take a few minutes to look through it, you'll learn how to use all of the features of your new JENSEN stereo for maximum enjoyment. Before you begin, always disconnect the battery negative terminal. [. . . ] bend the strap , as necessary , to position it. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration. Select "LOW" when you are using low-level RCA radio input (RADIO LOW-IN). Pin # 1A 2A 3A 4A 5A 6A 7A 8A 9A 10A 11A 12A RADIO HI-IN 1B 2B 3B 4B 5B 6B White/Black POWER 1C Red 12-24V DC Input: Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected. not Used Black Blue Ground Trigger DC Output: Connect to existing radio wire or radio fuse. 2C 3C 4C White Gray/Black Gray Speaker Left + Not used Speaker Right + Speaker Left Not used Speaker Right Wire Color White Gray Green Violet White/Black Gray/Black Breen/Black Violet/Black Orange Orange/Black Function Driver Speaker L+ Driver Speaker R+ Passenger Speaker L+ Passenger Speaker R+ Driver Speaker LDriver Speaker RPassenger Speaker LPassenger Speaker REXT Speaker + EXT Speaker Not Used Not Used SPEAKER OUT Power Press the POWER button or any other button on the face of the unit to turn the unit on. AUX RCA Connections The RCA connections for the AUX input audio channel, labeled AUX IN 1 and AUX IN 2, are located on the back of the unit. DVD Source Button Press the DVD button to play the audio from the optional DV352 DVD player through the selected speakers. the illuminated DVD indicator will change from green to red , indicating the selection was made. An 8-Pin DIN connector and left and right audio inputs cables allow you to control the DV352 through the PADIN3. 5mm jacks (one for AUX1 and one for AUX2) on the back of the unit in which you can plug the IR source signals. The AUX IN device can then be controlled with the AUX remote through the IR sensor on the front of the PADIN3. NOTE: If using a wireless remote with the DV352, the DV352 wired IR connection must be plugged into AUX1 IR or AUX2 IR. [. . . ] La alimentación no va a la unidad Ninguno de los altoparlantes funciona (las luces del visualizador funcionan) No todos los altoparlantes funcionan El fusible en-línea está quemado El fusible en-línea está quemado Does not operate (display No power to yellow wire does not light) No power to red wire Inline fuse blown No power to unit No speakers operate Inline fuse blown Speaker harness not connected Incorrect splices or connections Speaker wires shorting to Check splices and chassis ground or to each connections. Other Blows fuses Power wire shorting to ground Make sure wire is not pinched. Speaker wires shorting to Make sure wire is not ground pinched. [. . . ]