User manual JENSEN JTA-475

[. . . ] II Thank you for choosing the JTA-475 Navigator as your door-to-door in-car navigator. The memory card version is very easy to use. Read the Quick Start Guide first and start using The JTA-475 Navigator right away. This document is the detailed description of the software. [. . . ] This menu point is only available on the Map screen and if there are no POIs near the cursor (i. e. only the address is shown in the Popup Info window). POI: opens the list of POIs near the selected point. These are the POIs shown in the Popup Info window. If you want to add a new POI at the cursor, you can do so by tapping New in the bottom left corner. This menu point replaces Add POI and it is only available in the Map screen and if there is at least one POI item near the Cursor. · 4. 5. 14 Current street (No. 16) This field of the Cockpit screen shows the name or number (as available) of the current street or road you are driving on. Tip: Some roads have an alternative name (or number). This is normally shown together with the primary name in this field. You can hide these alternative names in Map settings (5. 2. 3). 4. 5. 15 Travel and Route data (No. 17) The contents of these three fields are different when cruising (without an active route) or navigating (following an active route). When The JTA-475 Navigator needs to recalculate the route, the arrow will not jump back to the left as when reaching a via point, but it may drift a bit as the length of the new route may be different from the previous one. When the data corresponding to the entire route is displayed in the fields below, the line is colored the same way as the route line shown on the map. When you see data that belongs to a via point, the route is colored only up to that via point. 4. 6. 1. 2 Distance Left This value can also be displayed in one of the Route data fields on the Cockpit screen as `Distance to destination'. This is the distance you need to travel on the route before reaching your final destination. If via points exist, tap and tap again any of the fields to see the distance to reach the first, second, etc. 4. 6. 1. 3 Method This field shows how the route was calculated. It either displays the `Route' or the `Vehicle' field from the Route parameter settings. If you have chosen Car, Taxi, Bus or Lorry, the type of the route (Fastest, Shortest or Economical) will be displayed here; if you have selected Emergency, Bicycle or Pedestrian, this information will be displayed here. 4. 6. 1. 4 Time Left This is an estimated value that can also be displayed in one of the Route data fields on the Cockpit screen as `Time to destination'. It shows the time needed to reach the final destination of the route based on information available for the remaining 40 segments of the route. [. . . ] POI items are categorized to let you locate them more easily. On this screen you can see the first page of the top level POI categories. There are three levels altogether. The search will be carried out around a certain reference point. Always look at the current reference point shown in the green field above the POI category buttons and confirm that it matches what you want. [. . . ]