User manual JENSEN VOYAGER AOM-701

[. . . ] When backing up, proceed cautiously and be prepared to stop. Installation Location It is unlawful in most jurisdictions for a person to drive a motor vehicle equipped with a television viewer or screen located at any point forward of the back of the driver's seat or in any location that is visible, directly or indirectly, to the driver while operating the vehicle. The AOM701 product is designed to be used primarily as a rear observation device in conjunction with closed circuit cameras. [. . . ] When the unit is turned on all other buttons will be illuminated. When off only the Power button will be lit. * Note: Please note that when the unit is in the standby mode, trigger wire is triggered, the Power button #1 will not function. 4 A B 2. A/B Input Select Button This control toggles the active display image back and forth between AV1 and AV2 inputs. AV1 is the default source for the Blue Standby trigger wire. Day/Night Mode Button This control toggles the unit between "Day" and "Night" LCD illumination modes. In the "Day" mode, the LCD backlight intensity is at maximum. In "Night" mode, the LCD backlight is dimmed to a preset level that is more suitable for low light operation. Picture Adjustment Menu Button This control accesses an On-Screen-Display (OSD) menu for four LCD picture adjustments (Brightness, Contrast, Color, and Tint). The first depress of the button accesses the "Brightness" adjustment. The Volume +/- controls adjust the level, which is indicated by the bar graph at the bottom of the screen. Each consecutive depress of the Picture button accesses the adjustment screen for each picture adjustment. If no buttons are pressed within 6 seconds or controls other than the Picture and Volume buttons are pressed, the unit will exit the Picture Adjustment mode. ­ + 5. Volume +/- Buttons This 2-button set of controls adjusts the output volume of the built-in audio speaker when the audio function is enabled *(see typical system connection diagram). The "+" button increases output volume. The "-" button decreases output volume. Volume level is indicated by the OSD bar graph at the bottom of the screen. These buttons also serve as adjustment controls while in the Picture Adjustment Menu mode (see above section for details). [. . . ] Plug camera extension cable (available separately) into AV1 or AV2 input connector on the connection cable. Plug observation camera into camera extension cable. Make sure all cables are routed away from hot or moving parts, and away from sharp edges. [. . . ]