User manual JENSEN VOYAGER CDX3010

[. . . ] T H E A N T E N N A S H O U L D N O T B E L O C A T E D W IT H IN 2 4 " O F AN Y O BJEC T O R R O O F ED G E. PREPARATION Please read all instructions before beginning the installation. Tools and Supplies · · · · · · Drill or Battery Driver with a #2 Phillips Bit ½" Drill Bit Caulking Gun Tube of Approved Exterior Roof Caulk RG-6U Coaxial Cable 16AWG Power & Ground Wire F IG U R E 1 2 ANTENNA INSTALLATION 4. Remove metal base from plastic housing by removing the lock screw and sliding the base away from the plastic stalk. Drill 5/8" hole for the coax cable. Pre-drill the 3 mounting screws holes with a 1/8" bit. [. . . ] Pre-drill the 3 mounting screws holes with a 1/8" bit. Route RG6 Coax from wall plate through hole. See Figures 2, 3, & 4. 3 - 1/4"x14 SCREWS (INCLUDED) MOUNTING BASE FRONT OF VEHICLE LOCK SCREW ANTENNA APPLY APPROVED CAULKING COMPOUND AROUND THE 4 HOLES CENTER LINE OF ROOF DRILL 5/8" HOLE FIGURE 3 MOUNTING BASE A P P L Y A P P R O V E D C A U L K IN G C O M PO UN D 4 PLAC ES FIGURE 2 5. Apply approved caulking compound around all holes. Secure base using the included 3 screws. Apply approved caulking compound to screw heads and fill ½" hole with caulking compound. Connect the 2 coax cables ensuring the fitting is snug (Do Not Over tighten). Reinstall the plastic housing onto the base. Additional caulking compound may be applied to the outside seam of the base. Please note there is a moisture weep hole at the rear of the base. Select the desired source by moving the switch located on the front of the wall plate. Select either "AIR" or "CABLE". AIR will activate the roof mounted antenna which will provide over-the-air TV and AM/FM reception. Selecting CABLE will enable you to receive signals from your external Cable Service provider and AM/FM reception. Selecting "OFF" will disable the system completely and is recommending when the vehicle is not in use or storage. Note the Red LED indicator will be On in the "AIR" & "CABLE" positions. Next turn on all TV's and access your on screen menu. If you selected "AIR" ensure that TV tuner is set to receive over-the-air ATSC/NTSC signals. Activate the TV's auto programming sequence to scan / store available channels. If you selected "CABLE", then set your TV tuner to cable and activate the TV's auto programming sequence to scan / store available channels. [. . . ] If you selected "AIR" ensure that TV tuner is set to receive over-the-air ATSC/NTSC signals. Activate the TV's auto programming sequence to scan / store available channels. If you selected "CABLE", then set your TV tuner to cable and activate the TV's auto programming sequence to scan / store available channels. The 7. 5 Amp DC Receptacle is designed to power DC TV's or other small amperage DC devices. [. . . ]