User manual JENSEN VOYAGER JDV8035

[. . . ] When Driving Keep the volume level Iow enough to be aware of the road and traffic conditions. When Car Washing Do not expose the product to water or excessive moisture. This could cause electrical shorts, fire or other damage. CAUTION: To avoid an accident, the driver must not watch video while driving. [. . . ] Beep Tone Turn the rotary encoder to choose whether and audible beep is heard when a function is selected: "BEEP ON" or "BEEP OFF". It is recommended to turn the rear speaker "OFF" when using headphones. when the rear speaker is "OFF" , the "FADER" audio function is disabled. Internal Amplifier (Inter Amp) Turn the rotary encoder to turn the system's built in amplifier on/off. It is recomended to turn the internal amplifier "OFF" when connected to an external amplifier. X-Bass Only appears when X-Bass function is turned on. The following chart depicts the curve characteristics for each step: Use the tune/track |||< or >||| buttons (18, 19) to cycle through only the toplevel menu functions, and then press the rotary encoder to select the various adjustment options for that feature. Turn the rotary encoder to select settings for each option. The unit automatically exits audio control mode after five seconds of inactivity. Sub-W Only appears when subwoofer function is turned on. Chart depicts the curve characteristics for each step: Middle Quality Factor Curve Characteristics Treble To adjust Treble options, press the rotary encoder (4) repeatedly until "TREBLE" appears in the display. to store a station , turn the radio on and select the desired band and station. Press and hold a preset button (numbered one through six on the face of the radio) for more than two seconds. When stored, the preset number (CH1 - CH6) appears on the display. During FM radio operation, the JDV8035 will automatically pickup a stereo signal, when available ("ST" appears on the display). When no stereo signal is available, the unit automatically reverts to mono operation. With the label surface facing up, gently insert the disc into the slot until the soft-loading mechanism engages and disc play begins. The front panel will close automatically and "Reading. " will appear on the screen while the disc loads. NOTE: The unit is designed for play of standard 5" (12 cm. ) CD singles in this unit, either with or without an adaptor, as damage to the player and/or the disc may occur. Such damage will not be covered by the warranty on this product. [. . . ] When the vehicle warms up during cold weather or under damp conditions, condensation may appear on the lens of the disc player. Should this occur, the player will not operate properly until the moisture has evaporated. The unit is designed with a vibration dampening disc mechanism to minimize interruption of disc play due to normal vibration. When driving on rough roads, however, occasional sound skips may occur. [. . . ]