User manual JENSEN VOYAGER JE1507

[. . . ] Tampering To prevent electrical shock, DO NOT OPEN THE MONITOR CASE. There are potentially harmful voltages inside the monitor. There are no user serviceable parts inside. If evidence of tampering is detected, the warranty will be considered void. [. . . ] 4 TRIGGER (+12V) STANDBY ACC (+12V) TRIGGER (+12V) AUDIO POWER HARNESS QTY. 1 1· 2· 3· 4· 1· 2· 3· 4· · · · · · · · · · · · · GND 2 AV STOP DISTANCE MARKER STICKER QTY. 1 CONNECTION CABLE QTY. 1 4" BLACK WIRE TIE QTY. 4 1 AV STOP 3 CONTROLS AND OPERATION A B ­ + 1 2 3 4 5 1. Power/Stand-By Button The Power / Stand-by Button has two possible operations modes. Manual mode - Turned on manual by the user by pressing the Power #1 button. Stand-by mode - Turned on by a stand by trigger wire generally connected to the vehicles 12V reverse backup lights. Manual Mode wiring - For manual mode operation, the AOM701 should be wired as follows: ACC (+12V) Red wire should be connected to the vehicles accessory feed. GND - ground wire should be connected to chassis ground. Standby Mode wiring - For Standby mode operation, the AOM701 should be wired as follows: ACC (+12V) Red wire should be connected to the vehicles accessory feed. GND - ground wire should be connected to chassis ground. Standby / Reverse trigger blue wire should be connected to the reverse feed of the vehicles backup lighting system. Clamp all wires securely to reduce the possibility of them being damaged during installation and use. Keep all cables away from hot or moving parts, and electrically noisy components. Wiring Definitions: ¡ Power connection: Pin 1 Pin 2 Pin 3 Pin 4 ACC +12V (Red) Standby Trigger (Blue wire) Ground (Black wire) Audio Trigger (White wire) ¡ ¡ ¡ Camera A input: Camera B input: LCD panel: Connection for camera or camera extension cable Connection for camera or camera extension cable 12-pin DIN cable connection. Procedure: 1. Choose the monitor, junction box, and camera mounting locations. A ¾" (19mm) hole should be drilled for passing cables through vehicle walls, barriers, etc. After the intermediate cable is passed through the hole, install the split grommet (included). If additional cable protection is required install convoluted tubing over the cable. After cable/wiring has been routed and components are in place, temporarily make all system connections and perform a system function check. If system does not operate properly, see the troubleshooting section of this manual. If using an optional PanaVise® stalk mount (available separately), use the mounting template provided on page 11. Install the PanaVise® mount to the LCD monitor using the #10 self-drilling screws (included). [. . . ] If the connection cable is mounted further from the monitor, use the 5' intermediate cable included with the AOM701 to connect the monitor to the connection cable. If more cable length is needed, additional 5' lengths of the intermediate cable can be purchased. (See the accessory list at the back of this manual for part number details. ) 6. Connect the 4-pin power harness to vehicle. [. . . ]