User manual JENSEN VOYAGER JE2707

[. . . ] ELKHART, IN 46514 Visit us at http://www. asaelectronics. com 7" MONOCHROME OBSERVATION AOM-78 Features: 7" Monochrome Monitor Dual Camera Input Brightness/Contrast/Day-Night Controls Volume Control for Internal/ External Speaker Power/Stand by Button Front Panel Controls Back Lit AOM-78 POWER A B INPUT DAY/NIGHT + + + UDIOVOX PECIALIZED PPLICATIONS, L. L. C. FEATURES : AOM-78 Monochrome 7" Monitor Day/night switch Brightness and contrast controls Volume control Illuminated front panel Power/stand-by switch Internal speaker with external speaker jack IMPORTANT : Congratulations on your purchase of a Voyager AOM-78 monitor. With proper installation and use, your AOM-78 is designed to provide you with years of troublefree operation. This manual contains important information required to properly install and operate the unit. Please read this manual thoroughly before beginning. [. . . ] BY - Monitor operates when vehicle transmission is switched into " REVERSE ". ON - Monitor and system operate when ignition switch is " ON ". * MONITOR FRONT VIEW 2. Input switch " A " used mainly for rear mounted camera or as specified by the installer. " B " used mainly for side or mirror mounted camera or as specified by the installer. Day / Night switch Pre-set brightness and contrast levels optimized for day and night operation. POWER A B INPUT DAY/NIGHT 4. Should be adjusted if the " DAY / NIGHT " switch does not achieve the most desirable picture. Brightness Variable control of brightness. Should be adjusted if the " DAY / NIGHT " switch does not achieve the most desirable picture. Volume Variable control of internal speaker and external speaker volume. + + + Rear of Monitor 1. Power connection : Pin 1 not used Pin 2 Ground - black wire Pin 3 Reverse circuit - blue wire Pin 4 not used Pin 5 battery backup - yellow wire Pin 6 + 12VDC ignition - red wire 2. Camera A input connection to camera extension cable. Any moisture Inside the monitor could cause extensive damage. Use the thumbscrews to mount the monitor to bracket. 2. 250 3. 000 BEFORE INSTALLATION : 1. This system operates from 11 volts DC to 30 volts DC, negative ground. Please install this system according to the instructions in this manual. Do not disassemble the camera or the monitor. Disassembling the camera will compromise the waterproof seal. Connect the system to an ignition switched power source. Connection to a battery source will reduce battery life. 20 20 WIRING CAMERA AND MONITOR 1. See wiring diagram for connections to ignition, ground and back-up circuit (See Fig. Wiring Camera : Drill a 19 mm / " diameter hole into vehicle body near the camera and bracket. Connect camera connector to extension cable in vehicle. [. . . ] Apply sealant around grommet to increase resistance to water penetration. Wiring Monitor : Insert extension cable into camera #1 position if (2) camera are used, be sure to mark each extension cable property and plug second cable into camera #2 position. Bundle excess cable together using a cable tie or vinyl tape. This will avoid possible damage to cable during operation. [. . . ]