User manual JENSEN VOYAGER JHD1120

[. . . ] JHD1120 AM/FM/WB/AUX-IN Heavy Duty Radio Installation and Operation Manual Guide d'installation et d'opération AS/PS DN UP PTY MENU TF iPod DISC WB M P3 AM 1 FM 2 SAT 3 ST PS TITLE AR TIST CH. NA ME CA T MEN U LD CO MPOSER R PT IN T RDM ALARMSLEEP INFO ENTER JHD1120 40W x 4 JHD1120 CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The unit will automatically exit the audio menu after five seconds of inactivity. The following menu items can be adjusted. Bass Level Use the rotary encoder (1) to adjust the Bass level range from "-7" to "+7". Treble Level Use the rotary encoder (1) to adjust the Treble level range from "-7" to "+7". Balance Adjusting Balance controls the relative level between the left and right speakers in each pair. Use the rotary encoder (1) to adjust the Balance between the left and right speakers from "L 12" to "R12". POWER Volume Control To increase the volume, turn the rotary encoder (1) to the right. To decrease the volume, turn the rotary encoder to the left. Fader Adjusting Fade controls the relative level between the front and rear speaker pairs. Use the rotary encoder (1) to adjust the Fader between the rear and front speakers from "R12" to "F12". The maximum volume setting is 40. 5 JHD1120 System Menu 1. · · · · · · Press and hold the PTY/MENU button (2) for more than 2 seconds to enter the system menu. The first menu item, "KEYBEEP", will appear on the display. Press the TUNE/SEEK |<< / >>| (18, 19) button repeatedly to navigate the system menu. Press the INFO/ENTER button (16) to select the desired item. Press the INFO/ENTER button again to adjust the selected menu item. KEYBEEP (Clk (click) / Bep (beep) / Off): Turn the audible beep On/Off (heard when functions/buttons are selected). TUNING (USA / EURO): Set frequency spacing for various regions. P-- CLOCK (1-10 / Off) CLK FMT (12Hour / 24Hour): Select 12 or 24 hour display mode. · Press the INFO/ENTER button (16) to view the clock set screen. · Press the INFO/ENTER button to move to the next digit. · Press the TUNE/SEEK |<< / >>| (18, 19) buttons to adjust the selected digit. PREONLY (On / Off): Turn preset-only tuning on/off. BAT ALRM (Off / On): When ON, radio will alert when vehicle battery voltage is below 10. 8 VDC. BAT OFF (Off / On): When ON, radio will automatically turn off when vehicle battery voltage is below 10. 8 VDC. [. . . ] Depending on where you are located, there is a possibility you will receive only a very weak signal or none at all. Also, similar to AM and FM signals, weatherband signals are subject to surrounding conditions, weather, obstructions of the signal by hills or mountains, etc. 9 JHD1120 CARE AND MAINTENANCE · · · · · Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. [. . . ]