User manual JENSEN VOYAGER JHD910

[. . . ] Before drilling the mounting holes, make sure the area behind the panel where the holes are desired is clear of wires and fuel, vacuum and or brake lines. Self-Tapping Screws (Hole size 7/32") Machine Screws with Nuts (Hole size 7/32") Double-Sided Tape Mounting Stack Mounting machine screw Bracket metal Vehicle mounting surface Washer Nut 5 JHD910 Wiring The wiring diagram depicts all the wiring connections required for proper operation of the unit. Antenna Connector (Black Wire) 9-Pin Connector (Male) PCB 1/4"HEADPHONE OUTPUT Black Wire NUT WASHER Heat Shrink Tubing RUBBER CAP VEHICLE PANEL OR HEADPHONE MOUNTING BRACKET 3A FUSE Left Speaker + (White) Left Speaker (White/Black) Ground (Black) Accessory (Red) Note: Do not connect the red wire to a constant power connection. It should be connected to a vehicle connection with switched power, such as IGN or ACC. Right Speaker + (Gray) Right Speaker (Gray/Black) 6 JHD910 Basic Operation 1. Power Press the power button (1) momentarily to turn the unit on or off. [. . . ] When no adjustment is made for ten seconds, the time will be set and normal operation will resume. 9. Audio and Menu Adjustment Audio Adjustment Press AUDIO/MENU (9) momentarily to step through the following audio adjustment options: Bass, Treble and Balance (left to right). When the desired option appears in the display, press VOL+ (7a) or VOL- (7b) to adjust that audio feature. When no adjustments have been made for three seconds, the unit will resume normal operation. Menu Adjustment Press AUDIO/MENU for more than three seconds to enter menu adjustment mode and adjust any of the menu options: When the desired option appears in the display, press VOL+ or VOL- to adjust that menu option. When no adjustments have been made for three seconds, the unit will resume normal operation. The following menu options may be adjusted using this feature: · · · · · · · Beep Confirm (On or Off) - Determines if a beep will be heard each time a button is pressed. Operation Region (USA or Euro) - Selects the appropriate operating region. Clock Display (12 or 24) - Selects a 12-hour or 24-hour clock display. Display Brightness (Low, Mid or High) - Determines brightness level of the display. Backlight Color (Amber or Green) - Determines the backlight color of the unit. Turn On Volume (0-40) - Selects desired volume level for the unit to assume when turned on. WB Alert (On or Off) - Determines if the weather band alert feature is activated. 8 JHD910 Tuner Operation 10. Select a Band Press AM/FM (10) momentarily to directly access tuner mode from any other function mode. When the unit is already in tuner mode, briefly press AM/FM to change between two AM bands (AM1 and AM2) and three FM bands (FM1, FM2 and FM3). Note: If the unit is programmed for European operation, the sequence will be MW1, MW2, FM1, FM2 and FM3. 11. Manual Tuning Press TUN- (11a) or TUN+ (11b) momentarily to tune the frequency one step higher or lower. [. . . ] 131. 6 (W) x 47. 5 (D) x 86 (H) Loading Impedance. Bass (at 100 Hz), ±10 dB; Treble (at 10 kHz), ±10 dB Current Drain. . 1. 5 Ampere (max) FM Tuner Tuning range . [. . . ]