User manual JENSEN VOYAGER MCD5060

[. . . ] MCD5060 MARINE CD PLAYER / RECEIVER Installation and Operation Manual MCD5060 MCD5060 SAFETY INFORMATION When Driving Keep the volume level Iow enough to be aware of the road and traffic conditions. Protect from Water Do not expose the product directly to water, as this can cause electrical shorts, fire or other damage. Protect from High Temperatures Exposure to direct sunlight for an extended period of time can produce very high temperatures inside your vehicle. Give the interior a chance to cool down before starting playback. [. . . ] If removal keys are inserted at an angle, they will not lock properly to release the unit. Dashboard 2. Removal Key Trim Plate Installation Push the trim plate against the chassis until it is fitted. You must do this before you install the control panel, otherwise it can't be attached. 3 MCD5060 DIN Rear Mount (Method B) This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to mount the radio to the dashboard. Please consult with your local mobile stereo shop for assistance on this type of installation. Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used to mount the new radio. Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select a position where the screw Screws holes of the bracket and the screw holes of the main unit Dashboard are aligned (are fitted). Tighten the screws at 2 places on each side. Do not Factory exceed M5 x 9 MM maximum Mounting screw size. Longer screws Bracket may damage components Hook (Remove) inside the chassis. Wire the new radio to the vehicle as outlined in the Universal Installation instructions. Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1. · The DCP can easily be damaged if dropped or subjected to a strong shock. When the release button is pressed and the DCP is unlocked, the vehicle's vibrations may cause it to fall. To prevent damage to the DCP, always store it in a protective case after detaching it. The rear connector that connects the main unit and the DCP is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. If the DCP is dirty, remove debris with a soft, dry cloth only. You can use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the DCP. · · 4. 5. NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation. Reconnect Battery When wiring is complete, reconnect the battery negative terminal. Detachable Control Panel (DCP) Removing the Detachable Control Panel (DCP) 1. Attach the panel at the right side first, with point B on the main unit touching point A on the DCP (as shown in the diagram). [. . . ] CD play starts when the button is released. Play/Pause Disc Playback (1/PAU) Press the 1/PAU button (12) to suspend disc play. Press the 1/PAU button again to resume disc Play. Intro Scan (2/INT) Press the 2/INT button (13) on the control panel to play the first 10 seconds of each track sequentially. [. . . ]