User manual JENSEN VOYAGER MS6151DC SCHEMA

[. . . ] 6 3. 1 3. 2 Mechanical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 4. SYSTEM OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 4. 8 4. 9 4. 10 4. 11 4. 12 4. 13 4. 14 4. 15 Choosing a Location. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Indicators and Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Turning On the System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Determining Satellite Elevation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Entering Satellite Elevation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Automatic Elevation Determination. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Deploying and Stowing the Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Automatic Receiver On/Off. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 What is "Peaking?" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Automatic Satellite Signal Acquisition and Peaking. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Re-Peaking the Satellite Signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Automatic Power Interruption Recovery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 The Antenna Status Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 The Stow Light. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Auto Stow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 5. SEMI-AUTOMATIC OPERATING MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 5. 1 5. 2 Locating the Satellite . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Stowing the Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 M-01345 Page 2 TABLE OF CONTENTS (CONTINUED) 6. 11. TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The lamp represents the satellite and the straw is your satellite dish. As the straw points closer to the lamp, more light is visible through the straw. When the straw points directly at the center of the lamp, the most light is visible through the straw, and you have found the peak of the lamp's "signal. " Pointing at the signal's peak gives you the best possible reception in all weather conditions. 4. 10 Automatic Satellite Signal Acquisition and Peaking Satellite signal location and peaking is fully automatic. The rest of this section describes what to expect during the acquisition and peaking process. Your receiver is tuned to a channel, a message, "Searching for satellite signal, " appears. The status light on the antenna control unit will blink on and off evenly about once per second. When a signal has been located, your receiver will begin displaying the programming for the selected channel and the DBS-30500 will automatically begin finding the exact center of the satellite signal, or peak. When the system has located the signal peak, the status light will be on solidly, not flashing. The peaking process will usually take less than one minute. More time may be required during adverse weather conditions or if the signal is partially obstructed. 4. 13 The Antenna Status Light Table 1 defines the modes indicated by the ACU's Status light M-01345 Page 15 Table 1. Status Light Indications Blink Rate (per second) 0 1 1 5 10 Mode Steady off Flashing slowly and evenly Flashing slowly, on long/off short Flashing medium and evenly Flashing quickly and evenly Description Power switch is off or ACU is not plugged in. Antenna is moving to or from stow or is trying to acquire the satellite signal. See possible causes in Table 2. 4. 14 The Stow Light Important! The Stow light illuminates when the antenna is in the stow position. The light goes out when the antenna is no longer stowed. This indicator should be used to ensure the antenna is properly positioned for travel. It is also a good idea to visually check that the antenna is stowed before driving. Driving with the antenna in an operational position may cause damage or destruction to the antenna. Damage from driving with the antenna in an operational position is NOT covered by your warranty. 4. 15 Auto Stow The DBS-30500 will stow automatically if the satellite signal is lost for 30 seconds. [. . . ] Peaking ­ the process of locating the peak signal strength. Signal Peak ­ in referencing the DBS-30500 system, it is the position of the antenna at which the signal received by the receiver is strongest. M-01345 Page 19 8. Precautions To avoid injury, keep away from the dish when it is in motion and while it is plugged into the ACU. Do not open or remove any part of the ACU or the antenna. There are no user serviceable parts inside. [. . . ]