User manual JENSEN VOYAGER MSR200

[. . . ] this will prevent crimping and damage to the wiring. If the wiring must pass through a metal hole, be sure to use a rubber grommet to prevent the wire's insulation from being cut by the metal edge of the hole. It is also recommended to apply sealing caulk to any opening that may potentially allow water to enter. Be sure to choose a location that is flat and has clearance above the unit to prevent any damage, as well as allow for ventilation. [. . . ] Press the POWER button (1) to turn the unit off. The POWER button is illuminated whenever the +12V DC Switched (red wire) is powered, regardless of whether the unit is on or off. Press and hold the AS/PS (15) button for more than three seconds to automatically select six strong stations and store them in the current band. The new stations replace any stations already stored in that band. After scanning the entire band once, the unit will switch to "Distant" mode for all subsequent Auto Store tuning. The unit will pause for ten seconds at each preset station. Press AS/PS again to stop scanning when the desired station is reached. During radio operation, received signals are usually in stereo mode as indicated by the "ST" icon. However, when the signals are weak or intermittent, you can activate the Local (LOC) mode by pressing the LO/DX button (20). This mode favors access to local stations whose signals are much stronger; thereby improving radio reception. Press the BAND button (16) to change between three FM bands and two AM (MW) bands. Press and hold the TUNE/TRK >>| or |<< buttons (18, 19) to automatically seek the next or previous strong station. The preset buttons (5-10) can be used to store 6 channels, allowing convenient access to your favorite channels. Press and hold a preset button (5-10) until the corresponding preset button number appears. Press the TUNE/TRK |<< / >>| buttons (18/19) to move between the three digits. Use the VOLUME +/- buttons (2) to select a number for each position. Press the MODE button for each digit to enter "000". This will display the Sirius ID number for your tuner. The Sirius ID number will scroll twice and then freeze with the first 11 digits on the display. Each category title and song title will be displayed in increments. While in the category mode, press the CAT - /+ buttons again to view category names. (The lowest channel number within the chosen category will always be the default first channel tuned. [. . . ] (Most vessels employ this wire and resistor but it may be necessary to check them for correct operation. ) Another method of suppression is the use of additional noise suppressors. These can be obtained from most CB/A radio or electronic supply shops. Radio reception in a moving environment is very different from reception in a stationary environment (home). [. . . ]