User manual JETWAY 601CFR1C

[. . . ] 601CF Socket 370 s oG G G03-601CFR1C 2001 ~ 7 Ӽ: * * Pentium M MMXO ]tb Wθ ƶȬϥθ TѡA-קNtq tӪ աC IntelqUӼСCLӼФΦW٬ݨ qҦC A åB ϥΪ̻ UT ѨM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 601CF DO² DOS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Disabled (default) No warning message to appear when anything attempts to access the boot sector or hard disk partition table. Activates automatically when the system boots up causing a warning Enabled message to appear when anything attempts to access the boot sector of hard disk partition table. 3-6 Advanced Chipset Features The Advanced Chipset Features Setup option is used to change the values of the chipset registers. These registers control most of the system options in the computer. CMOS Setup Utility Copyright(C) 1984-2001 Award Software Advanced Chipset Features Advanced DRAM Control Advanced AGP Control Memory Hole System BIOS Cacheable Video RAM Cacheable Memory Parity/ECC Check [Press Enter] Press Enter Disabled Disabled Disabled Disabled Item Help Menu Level > :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults Note: Change these settings only if you are familiar with the chipset. Advanced DRAM Control Please refer to section 3-6-1 25 3-6-1 Advanced DRAM Control The "Advanced DRAM Control" includes settings for the chipset dependents features. These features are related to system performance. Make sure you fully understand the items contained in this menu before you try to change anything. You may change the parameter settings to improve system performance. However, it may cause your system to be unstable if the setting is not correct for your system configuration. CMOS Setup Utility Copyright(C) 1984-2001 Award Software Advanced DRAM Control Auto Configuration Precharge Command Active to CMD Command Write Recovery Time SDRAM Cycle Length Bank Interleave DRAM Drive Strength Delay DRAM Read Latch Memory Data Drive Memory CMD Drive DDSKEW/REFCLK Delay In-Order Queue P2C/C2P Concurrency Fast R-W Turn Around I/O Recovery Time CPU to PCI Write Buffer PCI Dynamic Bursting PCI Master 0 WS Write PCI Delay Transaction PCI#2 Access #1 Retry :Move Enter:Select F5:Previous Values [Optimized] 3T 6T 2T By SPD By SPD Auto 1. 0 ns Normal Strong No Delay 1-Level Disabled Disabled Disabled Enabled Disabled Disabled Disabled [Disabled] +/-/PU/PD:Value F10:Save F6:Optimized Defaults Item Help Menu Level >> ESC:Exit F1:General Help F7:Standard Defaults Precharge Command If an insufficient number of cycles is allowed for the RAS to accumulate its charge before DRAM refresh, the refresh may be incomplete and the DRAM may fail to retain date. Fast gives faster performance; and Slow gives more stable performance. This field applies only when synchronous DRAM is installed in the system. Active Command This field let's you insert a timing delay between the CAS and RAS strobe signals, used when DRAM is written to, read from, or refreshed. Fast gives faster performance; and Slow gives more stable performance. This field applies only when synchronous DRAM is installed in the system. Active to CMD Command Select the number of SCLKs for an access cycle. SDRAM Cycle Length 26 When synchronous DRAM is installed, the number of clock cycles of CAS latency depends on the DRAM timing. PCI Delay Transaction The chipset has an embedded 32-bit posted write buffer to support delay transactions cycles. Select Enabled to support compliance with PCI specification version 2. 1. The settings are: Enabled and Disabled. 3-7 Integrated Peripherals CMOS Setup Utility Copyright(C) 1984-2001 Award Software Integrated Peripherals > OnChip IDE Function > OnChip DEVICE Function > OnChip SUPERIO Function Init Display First [Press Enter] Press Enter Press Enter PCI Slot Item Help Menu Level > :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults OnChip IDE Function Please refer to section 3-7-1 OnChip DEVICE Function Please refer to section 3-7-2 OnChip SUPERIO Function Please refer to section 3-7-3 Init Display First This item allows you to decide to activate whether PCI Slot or AGP VGA first. The settings are: PCI Slot, AGP Slot. 27 3-7-1 OnChip IDE Function CMOS Setup Utility Copyright(C) 1984-2001 Award Software OnChip IDE Function OnChip IDE Channel0 OnChip IDE Channel1 IDE 32bit Transfer Mode Primary Master PIO Primary Slave PIO Secondary Master PIO Secondary Slave PIO Primary Master UDMA Primary Slave UDMA Secondary Master UDMA Secondary Slave UDMA IDE HDD Block Mode IDE Prefetch Mode [Enabled] Enabled Disabled Auto Auto Auto Auto Auto Auto Auto Auto Enabled Disabled Item Help Menu Level >> :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults 3-7-2 OnChip DEVICE Function CMOS Setup Utility Copyright(C) 1984-2001 Award Software OnChip DEVICE Function OnChip AUDIO Function OnChip USB USB Keyboard Support [Press Enter] Enabled Disabled Item Help Menu Level >> :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help F5:Previous Values F6:Optimized Defaults F7:Standard Defaults 28 3-7-3 OnChip SUPERIO Function CMOS Setup Utility Copyright(C) 1984-2001 Award Software OnChip SUPERIO Function Onboard FDD Function Onboard Serial Port 1 Onboard Serial Port 2 UART 2 Mode IR Duplex Mode TX, RX Inverting enable Onboard Parallel Port Onboard Parallel Mode ECP Mode Use DMA Parallel Port EPP Type :Move Enter:Select [Enable] Auto Auto Normal Half Ho, Yes 378/IRQ7 SPP 3 EPP1. 9 +/-/PU/PD:Value F10:Save Item Help Menu Level >> ESC:Exit F1:General Help F5:Previous Values F6:Optimized Defaults F7:Standard Defaults 3-8 Power Management Setup The Power Management Setup allows you to configure your system to most effectively save energy saving while operating in a manner consistent with your own style of computer use. CMOS Setup Utility Copyright(C) 1984-2001 Award Software Power Management Setup ACPI Function > Power Management PM Control by APM Video off Option Video Off Method MODEM Use IRQ Soft-Off by PWRBTN > Wake Up Events [Enabled] Press Enter Yes Suspend -> Off V/H SYNC+Blank 3 Instant-Off Press Enter Item Help Menu Level > :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults Wake-Up Events Please refer to section 3-8-2 29 3-8-1 Power Management CMOS Setup Utility Copyright(C) 1984-2000 Award Software Power Management Power Management HDD Power Down Doze Mode Suspend Mode [User Define] Disabled Disabled Disabled Item Help Menu Level >> :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults 3-8-2 Wake Up Events CMOS Setup Utility Copyright(C) 1984-2001 Award Software Wake Up Events VGA LPT & COM HDD & FDD PCI Master Modem Ring Resume RTC Alarm Resume x Date (of Month) x Resume Time (hh:mm:ss) > IRQs Activity Monitoring [OFF] LPT/COM ON OFF Disabled Disabled 0 0:7:0 Press Enter Item Help Menu Level >> :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults IRQs Activity Monitoring Please refer to section 3-8-2. 1 30 3-8-2. 1 IRQs Activity Monitoring CMOS Setup Utility Copyright(C) 1984-2001 Award Software IRQs Activity Monitoring Primary INTR IRQ3 (COM 2) IRQ4 (COM 1) IRQ5 (LPT 2) IRQ6 (Floppy Disk) IRQ7 (LPT 1) IRQ8 (RTC Alarm) IRQ9 (IRQ2 Redir) IRQ10 (Reserved) IRQ11 (Reserved) IRQ12 (PS/2 Mouse) IRQ13 (Coprocessor) IRQ14 (Hard Disk) IRQ15 (Reserved) [ON] Enabled Enabled Enabled Enabled Enabled Disabled Disabled Disabled Disabled Enabled Enabled Enabled Disabled Item Help Menu Level >>> Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit F5:Previous Values F1:General Help F6:Optimized Defaults F7:Standard Defaults 3-9 PnP/PCI Configuration Setup This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when communicating with its own special components. This section covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings. CMOS Setup Utility Copyright(C) 1984-2001 Award Software PnP/PCI Configurations PNP OS Installed Reset Configuration Data Resources Controlled By x IRQ Resources x DMA Resources PCI/VGA Palette Snoop Assign IRQ For VGA Assign IRQ For USB [No] Disabled Auto(ESCD) Press Enter Press Enter Disabled Enabled Enabled Item Help Menu Level > Default is Disabled. Select Enabled to reset Extended System Configuration Data ESCD) when you exit Setup if you have installed a new add-on and the system reconfiguration has caused such a serious conflict that the OS cannot boot 31 :Move Enter:Select F5:Previous Values +/-/PU/PD:Value F10:Save F6:Optimized Defaults ESC:Exit F1:General Help F7:Standard Defaults Resource Controlled By The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and Plug and Play compatible devices. [. . . ] EXIT 8 VIA |X@Xʵ{ VIA 8601 VGA Xʵ{ ALC -Xʵ{ VIA wʱ{ BIOS uWɯŽε{ PC-CILLIN2000 frXʵ{ CD e MAGIC INSTALL ؿ 35 CܻpUR 4-1 IDE IDE : AGPVXD : w w w VIA |X@Xʵ{ VIA ATAPI XA{ Bz Υ IDE mۮeʰDC VIAGART. VXD iH䴩 VGA d VIA AGPVXD Xʵ{C Xʵ{Aȵ{Ǥζ-wmAHѧֳtϧΦsC IRQ ROUTING : w VIA PCI IRQ MINIPORT Xʵ{ PCI _muwƶǡC (u䴩 Windows 98)Ci- INF : w VIA b Windows UU{C@Xʵ{iΨӱҰ q޲zmC VIA 1. b MAGIC INSTALL - -ӿﶵC IDE o 2. X{ VIA Service Pack Wizard ɡA NEXTC 3. NEXT AҦXʵ{C 36 NEXTAYiw˻syөҴѪ 5. [. . . ]