User manual JEUJURA CHALET SUISSE 8045

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] Works well with vocals, guitars, woodwinds. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. LARGE ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. Features very fast and scattered early reflections, long pre delay. Works well with vocals, woodwinds, strings. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. SMALL ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. Feature very fast and scattered early reflections, short pre delay. Works well with vocals, fingered guitars, drums. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one, alternating hall, tape, spring or plate types of reverb. Use these unbalanced RCA connectors to patch the output of a player, such as an analog tape deck, a DAT, a MD or a CD player. IMPORTANT: this input and the USB input are routed together, so we suggest to use only one of them at the same time. It adjust the level of the 2TRK INPUT and USB input (audio signal from a PC). Typically this button must be released to avoid problems with feedbacks when you use the mixer for recording the signal of the MIX bus. Use these unbalanced RCA connectors to send out the MAIN MIX signal to a recorder (such as an analog tape, a DAT or a MD recorder). Push in this switch to send the MIX bus signal to C. Push in this switch to send the GROUP 1-2 bus signal to C. Push in this switch to send the 2TRK input signal and USB input signal to C. NOTE: for a correct operation we suggest to choose these three switches (60) or (61) or (62) one at a time. IMPORTANT: these three switches also select which signal is displayed on LED METERS when none channel is soloed. STEREO JACK connector for the headphones output: only stereo headphones with a minimum impedance of 32 Ohms should be connected to this output. [. . . ] Assign each channel both to MIX (17)(37) and 1-2 (18)(38) buses. The MAIN MIX (83) fader now acts like a master recording level control for all your mic/line inputs. Adjust this knob until you're getting good levels into your PC recording DAW software. The GROUP 1-2 (80) fader now acts like a monitoring level control for all your mic/line inputs, but it does not affect recording levels in your PC. [. . . ]