User manual JOBO GIGA 2

[. . . ] The GIGA 2 is the smart solution to backup the data files into a portable hard disk. You do not need to worry about a full memory card stopping your photography anymore!Slim and light Easy operation Aluminium shell Compatible with all popular memory cards Huge capacity USB2. 0 interface Rechargeable internal battery The GIGA 2 is a USB2. 0 portable hard disk Supports 2. 5``HDD with 20GB Compatible with USB1. 1 FAT32 support for hard disk formatted. The GIGA 2 is also a 8 in 1 USB2. 0 memory card reader for nearly all popular memory cards when connected to your computer. [. . . ] Windows 2000 must have at least Service pack 3 installed, and Windows XP must have at least Service Pack 1 installed. 7 2. 2. Left click on the `Unplug or Eject Hardware` or `Safely Remove Hardware` icon in the Windows system tray ( green arrow icon on right of your task bar ). Select `stop USB Mass Storage Device`( for Windows 2000 ) or `Safely Remove USB Mass Storage Device` ( for Windows XP ) and confirm. Left click on the `Unplug or Eject Hardware` icon in the Windows system tray ( green arrow icon on right of your task bar ). Select `stop USB Disk- Drive ( F: ) ` ( or the appropriate drive letter ) and confirm. The GIGA 2 appears as three separate drivers in this Windows ME system tray icon, so go through steps 1 and 2 two more times until all three drives are disconnected. Open `My computer Control Panel System Device Manager`, right click on the GIGA 2 and select `remove`, then disconnect your GIGA 2. Note: Unplug the USB cable only when prompted or there is no data transfer evident. If not, you may damage your data in GIGA 2. Should this happen, you may use the Windows scandisk utility and attempt to repair any damaged data on the hard disk. 8 GB 2. 3. Turning Power On and Off Press the ON/ OFF button to turn on the GIGA 2. copying from a flash card into the Giga One. Insert a CF or SD/ MMC/ MS/ MS Pro/ MS Duo/ SM card into the appropriate card slot, (if both slots contain cards, press the select button to select the card you want to copy). The LCD will display the flash media card inserted. Press the `COPY´ button to start copying. The LCD will display the progress in terms of estimated percentage completed and remaining battery power. When completed successfully, the LCD will display 100 %. If it fails to copy properly, the LCD will display the error message. Continued copy errors could indicate corrupted data on the card. To conserve the internal battery power, the GIGA 2 will power off automatically after the copy is completed. Turn on GIGA 2 again and the LCD will display the flash media card inserted. All copied files will be stored in the respective folders in the GIGA 2 hard disk, namely `SDD`( SD/ MMC ), `MSD`( MS/ MS Pro), `CFD`( CF/ MD ) and `SMD` ( SmartMedia ) and followed by xxxx ( 4 digits ) in which xxxx is the sequence number. 10 GB Note: When you copy SD card for the first time, the content will be stored in folder SDD_0001 Warning: DO NOT tamper or remove the flash media card while copy is in process. Doing so may result in damage to the Giga One that is not covered under warranty. [. . . ] Under no circumstance shall JOBO or our dealers be liable for any incidental, special or consequential damages that result from the use of the GIGA 2 or related documentation, including any kind of damage or loss of property, financial loss or loss of data. In no event shall our total liability to you for all damages, losses, and causes of action exceed the amount paid by you for the GIGA 2. The following cases are charged for service regardless of the term of guarantee: - Malfunction after exceeding the warranty period. - Malfunction due to misapplication or damage caused by careless handling. [. . . ]