User manual JOHN LEWIS JLFFW2004

[. . . ] JLFFW2004 frost free fridge freezer Instruction manual Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure thatthe book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance andthe relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. [. . . ] The highest temperature inside the freezer after pressing the "C" button twice (freezer symbol is dark), for a while. Refrigerator temperature set (value is blinking) when the "F" knob is rotated and for a while afterwards. Freezer temperature set (value is blinking) when the "B" knob is rotated and for a while afterwards. Super cooling symbol Visible, when the appliance runs in super cooling mode. High temperature symbol Visible, when the temperature in the refrigerator is too high. See also the description on the display background colour. Shopping symbol Visible, when the appliance runs in shopping cooling mode. See also the chapter on using the refrigerator. Display background colour By default the display background is blue. When ever a control button or knob is used the background turns bright blue and remains so for a while. The display background turns red, if the temperature inside the freezer is too warm (alarm). If this is the case, the digits blink the warmest temperature inside the freezer, the high temperature symbol flashes and an acoustic alarm signal is shown. The temperature might be too warm in the following cases: Immediately after switching on The freezer door was left open for a longer time There is an operating trouble in the freezer To switch the alarm sound off press the "E" button. The display returns to showing the ambient temperature, however the background remains red until the freezer cools down properly. Should you press no button during alarm, press the "E" button when the sound finishes to see the warmest temperature reached during the alarm. Controlling the temperature, setting The Thermostat will stop and start the cooling system as frequently as is required to maintain the temperatures set within the two compartments. Temperature of the refrigerator and freezer can be set by knobs "F" and "B", respectively. The set temperature is seen blinking on the display. For everyday use the setting in the refrigerator should be +5°C; in the freezer the setting would be -18°C recommended, or slightly colder. Allow the appliance to run for a period of 24 hours whenever the temperature setting is changed. This will allow the temperature to stabilise inside the appliance. The temperature within the refrigerator is influenced by varying factors, the thermostat setting, the ambient room temperature, the frequency that the door is opened and closed and the quantity of food stored within. When the coldest temperature possible is set when there are eases of increased demand e. g. during heatwaves - the compressor may operate continually. This does not cause damages to the appliance. 11 Using the refrigerator For adequate cooling developing interior air circulation is necessary. [. . . ] Put the melting water outlet to the evaporative tray. Check if the doors close well and the gaskets are undamaged and clean. Set the thermostat knob to a position that gives higher temperature. Set the thermostat knob to a position that gives higher temperature. [. . . ]