User manual JOHN LEWIS JLTDC01

[. . . ] JLTDC01 condenser dryer with heat pump Instruction manual 1 Important Safety Information It is most important that this instruction manual should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before use or installation by a qualified person. [. . . ] Press the INTENSITY button repeatedly until the light for the residual moisture required is lit. In the programmes WOOL or SILK further drying can also be set by restarting the programmes with the residual moisture levels +, ++ or +++ set in addition, as required. In the case of a drying cycle with relatively dry laundry, the length of the programme cycle displayed at the beginning is corrected after a while. Important: Do not over dry wool or silk. Turn the programme selector to any programme or turn it to LIGHT. When the door is opened, the drum is illuminated. Opening loading door / loading laundry 1. Open loading door: Push against the loading door (push point ) 2. Load your laundry (do not force it in/overload the machine). ANTI-CREASE 1 Warning!Be careful not to trap laundry in between the loading door and rubber seal. Lock must audibly lock. Selecting the programme Use the programme selector to set the programme you require. The probable programme run time is displayed (in minutes) on the multi-display. If this additional function is selected, the anti-crease phase at the end of the drying cycle is lengthened by 60 minutes. The laundry can be removed at any time during the anticrease phase. ALARM When the drying cycle has finished, an intermittent acoustic signal will sound. 13 Setting time delay start of a programme by between 30 minutes (30' and a maximum of 23 hours (23h). 1. Select the programme 2. Press the DELAY START button as many times as necessary until the required start delay appears on the multi display, e. g. 12h if the programme is to be started in 12 hours. The DELAY START display is illuminated. 3 With the DELAY START button, you can delay the Drying cycle complete / removing laundry Once the drying cycle is complete, the END and CREASE GUARD indicators light up. If the ALARM button has been pressed, an acoustic signal sounds intermittently. 3 The drying cycles (except for the an anti-crease WOOL programme) are automatically followed by phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If ANTI-CREASE has been selected, the anti-crease phase is lengthened by 60 minutes. 2. Before removing the laundry, remove fluff from the microfine filter. It is best to use a damp hand for this purpose. (See "Cleaning and maintenance" section. ) 3. Remove laundry. [. . . ] Turn programme selector to LIGHT or to any programme. Automatic process; this is not a machine fault. Empty condensate tank, then start programme with START/PAUSE button. Select time programme or higher drying level (e. g. [. . . ]