User manual JOHN LEWIS JLUCFRW6001

[. . . ] JLUCFRW6001 refrigerator Instruction manual Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. [. . . ] To reverse the bottom hinge assembly proceed as follows: Disconnect the appliance from the electricity supply. Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar. Unscrew the 3 screws holding the lower door bracket. transfer the lower door hinge pin to the alternative position as shown in the top drawing. Unscrew the single screw at the bottom left hand side and retain . Replace the lower door bracket on the bottom left hand side but do not fully tighten the 3 screws. Remove the fridge door by gently pulling downwards and store to avoid damage. Unscrew the top door hinge pin of the refrigerator then screw it back on the other side. Replace the fridge door on the upper door hinge pin. Insert the lower door hinge pin into the door and tighten all screws. Re-fix the retained screw to the bottom right hand side and replace the 2 adjustable feet. WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. The plug must still be accessible after the appliance has been installed. The appliance should not be connected to the electrical supply by means of an extension cable. Permanent connection In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. Proceed as follows: 1. Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" orthe earth symbol or coloured green and yellow. Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter "N" or coloured black. Connect the Brown (live) wire to the terminal in the plug which is marked with the letter "L" or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must besecure over the outer sheath. 10 When the refrigerator is first installed General information This appliance is designed for the domestic use only. It has a four-star frozen food compartment for ice making and frozen food storage. Using the Appliance Before Use Remove all packaging and adhesive tape. Wash the inside of the appliance with lukewarm water and bicarbonate of soda (5 ml to 0, 5 litre of water). Do not use soap or detergent as the smell may linger. [. . . ] Turn the thermostat knob to a medium position to restart the appliance. After letting the appliance run for at least half an hour replace the previously removed food into the **** -star compartment. When defrosting it is not necessary to remove the foods from the inner door and the refrigerator compartment. External Cleaning Wash the outer cabinet with warm soapy water. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. Changing the Light Bulb Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. [. . . ]