User manual JONSERED CET 342

[. . . ] Close cover and secure latches over center support tubes. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging. Your bagger is equipped with a full bagger indicator. movement of the wheel increases as the bags fill. [. . . ] ASSEMBLY CHECK: Squeeze sides of lower half of container and check that there is no gap between upper and lower halves. Install one container to left side first (1). install other container to right side (2). NOTE: Left edge of right container should always overlap right edge of left container at center support (3). Close cover and lock latch handle (4) over center support tube (3). Place slot in lower chute over tab (2) on mower deck and position lower chute over deck opening as shown. Hook rear latch (3) into flange hole on back of mower deck. Hook front latch (4) into tab hole on front of mower deck. CAUTION: Do not remove deflector shield (1) from mower. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation. Lower mower to its lowest cutting position. Stop the blades from rotating before crossing surfaces other than grass. When using any attachments, never direct discharge of material toward bystanders nor allow anyone near the machine while in operation. Never operate the lawnmower with defective guards, shields or without safety protective devices in place. Do not change the engine governor settings or overspeed the engine. Operating the engine at excessive speed may increase the hazard of personal injury. Before leaving the operator's position: - disengage the power take-off and lower the attachments; - change into neutral and set the parking brake; - stop the engine and remove the key. Disengage drive to attachments, stop the engine, and disconnect the spark plug wire(s) or remove the ignition key - before cleaning blockages or unclogging chute; - before checking, cleaning or working on the lawnmower; - after striking a foreign object. Inspect the lawnmower for damage and make repairs before restarting and operating the equipment; - if the machine starts to vibrate abnormally (check immediately). Disengage drive to attachments when transporting or not in use. Stop the engine and disengage drive to attachment - before refueling; - before removing the grass catcher; - before making height adjustment unless adjustment can be made from the operator's position. Reduce the throttle setting during engine run-out and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. [. . . ] WARNING: Always disconnect spark plug wire and place wire where it cannot contact spark plug in order to prevent accidental starting when setting up, transporting, adjusting or making repairs. To reduce the risk of fire - before use, when refueling and at the end of each mowing session - inspect and remove any debris buildup from the tractor, mower and behind al guards. While mowing, always wear substantial footwear and long trousers. Do not operate the equipment when barefoot or wearing open sandals. [. . . ]