User manual JONSERED CS 2117 EL

[. . . ] Español Lea atentamente las instrucciones y asegúrese de entenderlas antes de utilizar esta unidad. 545079719 1/3/06 IDENTIFICATION (WHAT IS WHAT?) Chain Adjustment Tool (Bar Tool) Front Hand Guard Front Handle Starter Rope Idle Speed Screw Chain Muffler ON/STOP Switch Primer Bulb Bumper Spike Bar Oil Fill Cap Cylinder Cover Starter Housing Fuel Mix Fill Cap Throttle Lockout Rear Handle Adjusting Screw Chain Direction of Travel Throttle Choke/ Trigger Fast Idle Chain Brake Lever Chain Catcher Chain Brake Nuts Guide Bar Bar Sprocket Hole IDENTIFICATION OF SYMBOLS WARNING!Careless or improper use can cause serious or even fatal injury. Always wear appropriate ear protection, eye protection and head protection. Always use two hands when operating the chain saw. Read and understand the instruction manual before using the chain saw. Sound power level Sound pressure level at 7, 5 meters WARNING! [. . . ] If the chain moves at idle speed refer to CARBURETOR ADJUSTMENT within this manual. To stop the engine, move the ON/STOP switch to the STOP position. To start the engine, hold the saw firmly on the ground as illustrated below. Make sure the chain is free to turn without contacting any object. Hold saw firmly while pulling starter rope. Choke/ fast idle lever OFF HALF FULL 6. Pull the starter rope sharply with your right hand until the engine starts. Allow the engine to run for approximately 30 seconds. Then, squeeze and release throttle trigger to allow engine to return to idle speed. STARTING A WARM ENGINE 1. Pull the choke/fast idle lever out to the HALF CHOKE position. Pull the starter rope sharply with your right hand until the engine starts. Squeeze and release throttle trigger to allow engine to return to idle speed. DIFFICULT STARTING (or starting a flooded engine) IMPORTANT POINTS TO REMEMBER When pulling the starter rope, do not use the full extent of the rope as this can cause the rope to break. This is the only instance when the saw Braking function control CAUTION: The chain brake must be WARNING: When performing the following procedure, the engine must be turned off. Grip the rear handle with your right hand and the front handle with your left hand. Hold the chain saw approximately 14" (35 cm) above a stump or other wooden surface. Release your grip on the front handle and use the weight of the saw to let the top of the guide bar fall forward and contact the stump. When the tip of the bar hits the stump, the brake should activate. CUTTING METHODS IMPORTANT POINTS S Check chain tension before first use and after 1 minute of operation. See CHAIN TENSION in the ASSEMBLY section. Do not cut metal, plastics, masonry, non-wood building materials, etc. S Stop the saw if the chain strikes a foreign object. Inspect the saw and repair parts as necessary. Even a small amount of dirt will quickly dull a chain and increase the possibility of kickback. S Practice cutting a few small logs using the following techniques to get the "feel" of using your saw before you begin a major sawing operation. [. . . ] S Before storing, drain all fuel from the unit. Start engine and allow to run until it stops. Pay particular attention to the air intake area, keeping it free of debris. Use a mild detergent and sponge to clean the plastic surfaces. [. . . ]