User manual JONSERED CS 2234 S

[. . . ] Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in chapter Technical data and on label. Other symbols/decals on the machine refer to special certification requirements for certain markets. Protective goggles or a visor must be worn. Refuelling. Filling with oil and adjusting oil flow. The chain brake must be engaged when the chain saw is started. Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. [. . . ] The bar guard must always be fitted to the cutting attachment when the machine is being transported or in storage, in order to prevent accident contact with the sharp chain. Even a non-moving chain can cause serious cuts to yourself or persons you bump into with an exposed chain. ! · · · · Long-term storage Empty the fuel/oil tanks in a well ventilated area. Store the fuel in approved cans in a safe place. See instructions under the heading Maintenance schedule. 18 ­ English STARTING AND STOPPING Starting and stopping Warm engine Use the same procedure as for starting a cold engine but without setting the choke control in the choke position. The correct choke/start throttle setting is obtained by moving the choke control to the choke position and then pushing it in again. ! WARNING!Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Otherwise the clutch can come loose and cause personal injuries. Make sure you have a secure footing and that the chain cannot touch anything. Keep people and animals well away from the working area. H Starting Cold engine Starting: The chain brake must be engaged when the chain saw is started. Activate the brake by moving the front hand guard forwards. Grip the front handle with your left hand. This method is very dangerous because you may lose control of the saw. The engine is stopped by pushing the stop switch to the stop position. · · Never start the machine indoors. Exhaust fumes can be dangerous if inhaled. Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment. 20 ­ English WORKING TECHNIQUES Before use: Basic safety rules 1 · · Look around you: To ensure that people, animals or other things cannot affect your control of the machine. To make sure that none of the above might come within reach of your saw or be injured by falling trees. , 1 2 3 4 5 6 7 8 9 Check that the chain brake works correctly and is not damaged. Check that the rear right hand guard is not damaged. Check that the throttle lockout works correctly and is not damaged. Check that the stop switch works correctly and is not damaged. Check that all handles are free from oil. Check that the anti vibration system works and is not damaged. Check that the muffler is securely attached and not damaged. Check that all parts of the chain saw are tightened correctly and that they are not damaged or missing. [. . . ] If the bar has a sprocket tip, this should be lubricated. Check that the bar and chain are getting sufficient oil. File off any burrs from the edges of the bar. Check that the electrode gap is 0. 5 mm. Clean the outside of the carburettor. Check the fuel filter and the fuel hose. [. . . ]