User manual JONSERED GRASS CATCHER C 342 B

[. . . ] Do ct to da or subjeed ck cra r un ra a re INGmowe tierio ly on RNerate and de e Us WA t op wear ged. Re conta erlyi ently nt prop qu ceme r is g fre pla ine ba d re nta eck de en s co Ch les tion. comm r is taine en . Con wh led ce iner. Do ct to da or subjeed ck cra r un ra a re INGmowe tierio ly on RNerate and de e Us WA t op wear ged. Re conta erlyi ently nt prop qu ceme r is g fre pla ine ba d re nta eck de en s co Ch les tion. [. . . ] Place support tube over weld screws and assemble flat washer, lockwasher, and wing nut as shown Do not tighten at this time. Discard remaining shoulder bolts in hardware GROUP "A". SUPPORT TUBE REINFORCEMENT PLATE HEX BOLTS SHOULDER BOLTS LANCED TABS TOWARD BOTTOM FIG. 1A If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below (See Fig. Using the four formed holes in the drawbar, install the four self tapping shoulder bolts as shown and tighten securely. Hang the mounting bracket, lanced tabs towards bottom, on the bolts. Assemble the support tube to drawbar as shown. From backside of drawbar place reinforcement plate so that weld screws go through holes in left side of drawbar. Place support tube over weld screws and assemble flat washer, lockwasher, and wing nut as shown Do not tighten at this time. Discard remaining hex bolts and locknuts in hardware GROUP "A". FLAT WASHERS LOCK WASHERS WING NUTS LANCED TABS TOWARD BOTTOM LOCKNUTS FIG. 1C 7 ASSEMBLY 2 COVER SEAL (See Fig. Align mark on seal with mark at cover opening. Work seal into opening so cover sits between flanges of seal. 4 MOUNTING TO TRACTOR (See Fig. 4) Use Hardware - - GROUP "C & D" ALIGNMENT MARKS NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor. Raise seat on tractor to allow assembly to be mounted. With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket. Line up holes in mounting bracket with holes in support post and insert bracket support pin. Secure cover assembly to support tube using short hex bolt, long hex bolt, and locknuts as shown. NOTE: Hardware securing support tube to drawbar must be tightened at this time. Install the four (4) tubing end caps onto container support. Tap each end cap onto container support tubes to seat securely. COVER SEAL SHORT HEX BOLT LONG HEX BOLT COVER ASSEMBLY LOCKNUTS FIG. 2 BRACKET SUPPORT PIN RETAINER SPRING 3 SUPPORT POST (See Fig. [. . . ] ONCE YOUR MODEL TRACTOR CONFORMS TO THIS SECTION PROCEED TO ASSEMBLY. To Prepare your Grass Catcher you may need: (1) Drill Motor (1) 7/16" Drill Bit DRILL SUPPORT TUBE MOUNTING HOLES IN DRAWBAR (See Template) On some model tractors, two 7/16" holes must be drilled in left side of the drawbar for mounting the support tube. NOTE: To ease in drilling 7/16" holes, it may be necessary to drill smaller pilot holes at the locations indicated. 14 DRILL TWO 7/16" HOLES 1) CUT OUT TEMPLATE. 2) ALIGN BOTTOM AND LEFT EDGE OF TEMPLATE AND DRAWBAR. [. . . ]