User manual JONSERED ICT 13 A REV 1

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment. Never allow children or people unfamiliar with the instructions to use the lawnmower. [. . . ] Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backwards (1). Push in the button (2) and then move the lever forward (3). There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. Press down the brake pedal to bottom position. Move the parking brake lever upwards and hold in this position. To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the free-wheel control knob must be pulled out and locked in position. The cutting height is increased when it is turned clockwise. The wheel is easier to turn if the lever for lifting/lowering of the cutting unit is pulled backwards at the same time. The engine should be run of pure (not oil mixed) unleaded petrol. Do not fill beyond the lower edge of the filling hole. Proceed with care and fill up with petrol outdoors. Do not smoke when filling with petrol or fill up when the engine is warm. Do not overfill the tank since the pertrol can expand and overflow. Make sure that the petrol cap is securely tightened after filling. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. The oil level in the engine should be checked before each run. The oil level should lie between the two markings on the oil stick. If more oil is needed add SAE 30 oil to the "FULL" marking. [. . . ] The motion control lever has been preset at the factory and adjustment should not be necessary. Start engine and move motion control lever until tractor does not move forward or backward. NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position. After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps: · Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep. [. . . ]