User manual JONSERED ICT 15 REV 1

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. We reserve the right to make changes without prior notice. Be familiar with the controls and the proper use of the equipment. Never allow children or people unfamiliar with the instructions to use the lawnmower. [. . . ] Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. Adjust gauge wheels with tractor on a flat level surface. With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. The accelerator control regulates the motor speed and also the speed of the blades. Full speed lies between these two positions. When the pedal is pushed down the brake is applied and the motor is disengaged. The gear box has positions forward, neutral and reverse. Gear changing can take place from neutral to top gear without stopping in each gear position. Stop the machine before changing from reverse to forward gear, or the opposite. Gear changing between the forward gears must not take place when the machine is in motion. Move the lever forward to connect the drive to the cutting unit, whereby the drive belt is tensioned and the blades begin to rotate. If the lever is moved backwards the drive will be disconnected and the rotation of the blades slowed down by the action of the brake shoes on the pulley. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backwards (1). Push in the button (2) and then move the lever forward (3). There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. Press down the brake pedal to bottom position. Move the parking brake lever upwards and hold in this position. To release the parking brake all that is necessary is to push down the brake pedal. The cutting height is increased when it is turned clockwise. [. . . ] Screw the nut (2) the same number of turns on both levers. When the correct distance (A) is obtained this setting is locked with the nut (1). At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" should be the same or within 6mm (1/4") of each other. [. . . ]