User manual JONSERED LM 2146 C

[. . . ] Operator's Manual Read the operator's manual carefully and make sure that you understand the contents before using the lawnmower. Please read the user instructions carefully to fully identify, assemble and use the features that apply to your petrol wheeled rotary lanwmower Hinweis: Dieses Handbuch ist für verschiedene Produkte bestimmt. If not used properly this lawnmower can be dangerous!This lawnmower can cause serious injury to the operator and others, the warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this lawnmower. [. . . ] Following instructions in the Use - starting and stopping section. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Wait about two seconds between each push. In cold weather (55oF/13oC or below) push primer five times. Following instructions in the Use - starting and stopping section. Move throttle control (if fitted) to RUN or FAST position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. Please Note : Your upper handles may look different from those shown but the procedure remains the same Pull the OPC to the handle (L1), this releases the brake. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent (L2). After the engine has started, allow to run for 30 seconds before commencing to use. To stop your lawnmower - release the OPC lever Follow the above procedure for Push lawnmowers 2. Forward drive is engaged and disengaged with the Powerdrive lever at the top of the handle (M1). Releasing the Powerdrive Lever stops the forward drive automatically. To stop your lawnmower - release the Powerdrive lever, then the OPC lever. Before starting the engine for the first time, ensure free movement of the rear wheels by moving the machine backwards and forwards without operating the powerdrive lever (N1). Whilst moving backwards and forwards operate the gear change lever (N2) from low to high speed, if the rear wheels lock, the cable will require adjusting. Adjusting is achieved by turning the adjuster (N3) left or right until the machine can be pulled backwards without the wheels locking. Key Start Only - During mowing, your engine will recharge the battery Please note:- Your lawnmower can be started manually by following steps 1-5 in the PUSH section The Powerdrive may be engaged by following steps 2-3 in the Powerdrive section. Turn the key and hold until the engine starts (O1 and O2). The key will return to the original position when released. If the engine fails to start when you turn the key your battery may need charging. To stop your lawnmower - release the powerdrive lever, then the OPC lever. [. . . ] If any part is found to be defective due to faulty manufacture within two years of original purchase, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear. (e) The machine has not been serviced or repaired, taken apart or tampered with by any person not authorised by Electrolux Outdoor Products. [. . . ]