User manual JONSERED LM 2147 CMD

[. . . ] Do not use the appliance in closed or poorly ventilated environments. Do not top up with fuel with engine running. Switch off the engine and disconnect the spark plug before undertaking any maintenance work. Keep the power supply cable well away from the cutting tool. [. . . ] Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. replace worn or damaged blades and bolts in sets to pre serve balance. On multibladed machines, take care as rotating one blade can cause other blades to rotate. Operation Do not operate the engine in a confined space where dangerous carbon mon ox ide fumes can collect. Mow only in daylight or in good artificial light. avoid operating the equipment in wet grass , where feasible. Always be sure of your footing on slopes. For wheeled rotary machines, mow across the face of slopes, never up and down. Use extreme caution when reversing or pulling the lawnmower towards you. 1 2 3 4 5 6 7 8 9 10 11 Upper handles Fuel-enrichment pump Fastening knobs for upper handles Grass catcher Oil filler cap Oil drain plug Deck Adjusting levers for cutting height Spark plug Fuel cap Engine start-grip 12 13 14 15 16 17 18 Rear deflector Throttle lever Engine stop lever Reduction gear Ignition key Handle advance speed Clutch lever To cut the grass with the mulching system (no grass collection), lift the rear deflector panel and insert the cap by fixing it with the spring as shown in the figure. Always operate with the deflector or grasscatcher in the correct position. Always stop the engine before removing the grasscatcher or adjusting the height of cut. Never place your hands or feet underneath the deck or into the grass discharge chute while the engine is running. Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. Never lift the rear of the mower while starting the engine or during normal operation. Never place your hands or feet underneath the deck or into the rear discharge chute while the engine is running. 6l Oil must be added to the engine before use STARTING THE ENGINE (Fig. JII) Once the machine has been set up properly, start the engine as follows: a) Engines with choke system: when the engine is cold, position the accelerator lever (13) on START b)Operate the engine stop lever (14) to prepare the engine for start, keep lever pressed against handle while starting and using the machine (it operates the engine brake). C) Engines with primer system: Press the fuel-enrichment pump (2) located on the carburettor 3 or 4 times position the accelerator lever (13) on MAX. For further information and explanations, read carefully the user instruction manual of the engine. MANUAL STARTING: (While holding the engine stop lever (14)). [. . . ] g) The machine is owned by the original purchaser. H) The machine has not been used commercially. This guarantee is additional to, and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee - Replacing worn or damaged blades - Failures as a result of not reporting an initial fault. [. . . ]