User manual JONSERED LM 2153 CMDA

[. . . ] â· Do not change the engine governor settings or overspeed the engine. Operating the engine at excessive speed may increase the hazard of personal injury. Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade. [. . . ] Use extreme caution when reversing or pulling the lawnmower towards you. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. â· Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. â· Allow the engine to cool before storing in any enclosure. â· To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. If the fuel tank has to be drained, this should be done outdoors. These symbols may appear on your machine or in the literature supplied with the product. Put grass catcher frame into grass bag with stiff part of bag on the bottom. The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame. Do not drag the bag when emptying, it will cause unnecessary wear. The mower can be set to different cutting levels. All wheels must be in the same height positions, otherwise uneven cutting will result. Fill the tank with petrol, not oil-blended. Both lead-free and lead-containing petrol may be used. Do not fill with petrol while the engine is running. â· To start a cold engine, push primer (3) times before trying to start. [. . . ] The level should be between FULL and ADD. NOTE: the dipstick must be screwed all the way down in order to indicate correct oil level. Tighten the screw properly when reassembling. [. . . ]