User manual JONSERED LT 18 A

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. Be familiar with the controls and the proper use of the equipment. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. Local regulations may restrict the age of the operator. [. . . ] Free-wheel Control Lever To tow or move the tractor without the aid of the engine, the free- wheel control knob must be pulled out and locked in position with the needle spring. The cutting height is increased when it is turned clockwise. The wheel is easier to turn if the lever for lifting/lowering of the cutting unit is pulled backwards at the same time. When the engine is cold the choke should be pulled out before starting. When the engine has started and is running smoothly push the choke in. The engine should be run of pure (not oil mixed) unleaded petrol. Do not fill beyond the lower edge of the filling hole. Proceed with care and fill up with petrol outdoors. Do not smoke when filling with petrol or fill up when the engine is warm. Do not overfill the tank since the pertrol can expand and overflow. Make sure that the petrol cap is securely tightened after filling. The oil level should lie between the two markings on the oil stick. If more oil is needed add SAE 30 oil to the "FULL" marking. SAE 5W-30 oil should be used during the winter (below freezing point). Oil level The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. The oil level in the engine should be checked before each run. Tire air pressure Check the tire pressure regularly. The pressure in the front tires should be 1 bar (14 PSI) and 0. Starting of motor Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. Press down the clutch/brake pedal completely and hold down. Pull out the choke control (if engine is cold). Turn the ignition key to "START position". [. . . ] Boulon De Reglage TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT The motion control lever has been preset at the factory and adjustment should not be necessary. Start engine and move motion control lever until tractor does not move forward or backward. NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position. After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps: · Move the motion control lever 1/4 to 1/2 inch in the direction it is trying to creep. [. . . ]