User manual JONSERED LT 2317 CMA

[. . . ] Local regulations may restrict the age of the operator. â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. [. . . ] â· Adjust gauge wheels with tractor on a flat level surface. With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. The throttle control regulates the engine revs and thus the rotation speed of the blades. = Full speed = Idling speed When the pedal is pushed down the brake is applied and the motor is disengaged. There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backwards (1). Push in the button (2) and then move the lever forward (3). Ignition Lock There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. Pull out the choke control (if engine is cold). Turn the ignition key to "START position". Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started and push in the choke control as soon as the engine is running smoothly. Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. move motion control lever to neutral (N) position. Stop tractor by turning ignition key to "OFF" position. engage transmission by placing freewheel control in driving position. Start engine and move throttle control to slow position. [. . . ] Engage the parking brake and work off the belt upwards from the pulley (3), the clutch pulley (4). Push the belt up between two fan blades and rotate the fan clockwise until the belt comes loose (5). Take off the belt from the engine pulley (6). The motion control lever has been preset at the factory and adjustment should not be necessary. [. . . ]