User manual JONSERED LTH 13

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. Be familiar with the controls and the proper use of the equipment. â· Never allow children or people unfamiliar with the instructions to use the lawnmower. Local regulations may restrict the age of the operator. [. . . ] To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the freewheel control knob must be pulled out and locked in position with the needle spring. The cutting height is increased when it is turned clockwise. The wheel is easier to turn if the lever for lifting/lowering of the cutting unit is pulled backwards at the same time. The motor should be run on pure, minimum 87 octane petrol (unmixed with oil), leaded or unleaded. Proceed with care and fill up with petrol outdoors. Do not smoke when filling with petrol or fill up when the engine is warm. Do not overfill the tank since the pertrol can expand and overflow. Make sure that the petrol cap is securely tightened after filling. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. The oil level in the engine should be checked before each run. The oil level should lie between the two markings on the oil stick. If more oil is needed add SAE 30 oil to the "FULL" marking. SAE 5W-30 oil should be used during the winter (below freezing point). The pressure in the front tyres should be 1 bar (14 PSI) and 0. Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. Turn the ignition key to "START position". Do not run the start motor more than 5 seconds at once. If the engine will not start, wait about 10 seconds before the next try. When the engine has started let the ignition key go back to the "ON position". To ensure proper operation and performance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor. [. . . ] Push the belt up between two fan blades and rotate the fan clockwise until the bet comes loose. Eng TO ADJUST MOTION CONTROL LEVER The motion control lever has been preset at the factory and adjustment should not be necessary. If for any reason the motion control lever will not hold its position while at a selected speed, it may be adjusted at the friction pack located on the right side of transmission. Stop tractor by turning ignition key to "OFF" position and engage parking brake. [. . . ]