User manual JONSERED ST 2111 E

[. . . ] â· Never mow while people, especially children, or pets are nearby. â· Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. The main reasons for loss of control are: a) insufficient wheel grip; b) being driven too fast; c) inadequate braking; d) the type of machine is unsuitable for its task; e) lack of awareness of the effect of ground conditions, especially slopes; f) incorrect hitching and load distribution. [. . . ] There are four different positions for this lever: N = Neutral (no drive) S = Slow F = Fast R = Reverse The lever can be moved steplessly between S and F to ensure the required speed. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. to lower the unit: Pull the lever backwards (1). Push in the button (2) and then move the lever forwards (3). Ignition Lock There are three different positions for the ignition key: OFF ON START All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. Press down the brake pedal to bottom position. Move the parking brake lever upwards and hold in this position. To release the parking brake all that is necessary is to push down the brake pedal. To tow or move the tractor without the aid of the engine, the freewheel control knob must be pulled out and locked in position with the needle spring. Park tractor on level surface so it will not roll in any direction. Parking brake must be disengaged for the following procedure. Start engine and move throttle control to slow position. â· Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. Stop tractor by turning ignition key to "OFF" position. Start engine and move throttle control to slow position. â· Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times. â· Your tractor is now ready for normal operation. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/disconnec tion lever in position "connection". [. . . ] Fill in dates as you complete regular service As needed Change engine oil Lubricate pivot points Check brake operation Clean air screen Clean air filter and pre-cleaner Replace air cleaner paper cartridge Clean engine cooling fins Replace spark plug Check tire pressure Replace fuel filter Clean battery and terminals Check muffler Lubricate ball joints Toe-in adjustment Carburetor adjustment Every 8 hours Every 25 hours Every 50 hours Every 100 hours Every 200 hours Sharpening can be carried out with a file or grinding disc. It is very important that both blades are sharpened equally to avoid imbalance. Use gloves during tightening to protect the hands. The brakes are located inside the right rear wheel. [. . . ]