User manual JRC RADAR 3000

[. . . ] Thank you for purchasing the RADAR 3000 radar. It will provide many years of trouble free use when operated properly. To use your RADAR 3000 properly, please observe the following precautions: Read this manual thoroughly to gain a good understanding of the capabilities and requirements of this equipment. Store the manual in a safe location so that it does not become lost or damaged. [. . . ] To turn off the VRM, press the EBL/VRM key while VRM is highlighted. Selects FUNCTION menu, then press the JOYSTICK. Selects #2 VRM-SET, then press the JOYSTICK. The VRM2 appears highlight on the upper right corner of the display. 24 OPERATION Rotate the J-DIAL clockwise for outer direction or counterclockwise for inner direction to move the #2 variable range marker. The actual target distance appears on the center top of the screen in selecting unit. To turn off the #2 VRM, selects the FUNCTION-#2 VRM-OFF on the menu sheet. (4) Using cursor Touch the JOYSTICK, cross cursor appears on the screen. The cross mark will be move any direction by using the JOYSTICK and the range and bearing and Time-To-Go data and Lat/Loug of the cursor position will be displayed on the lower right corner on the display. It is necessary to connect with the equipment of the outside of NAV-AID, COMPASS for these displays. (Refer to 3. 6. 2) Then, it sets BEARING to "T". (Refer to 4. 18) It isn't possible to go if not setting POSITION to "LL". (Refer to 4. 16) The cross cursor and cursor data will disappear in approximately 8 seconds. 4. 12 BEARING MEASUREMENT (1) Using the bearing scale Using the bearing scale on the screen, visually estimate the bearing where the radial line of the bearing scale would pass through the center of the target. The bearing you obtain will be the target's relative bearing in degrees. If VRM is highlighted, press and hold the EBL/VRM key to change to EBL mode. Rotate the J-DIAL clockwise or counterclockwise to move the electronic bearing line to the center of the target. Target bearing appears on the center top of the screen in degrees. Bearing may be displayed in relative "R", true "T", or magnetic "M" depending on the menu selection. To turn off the EBL, press the EBL/VRM key while EBL is highlighted. Selects FUNCTION menu, then press the JOYSTICK. OPERATION 25 Selects #2 EBL-SET, then press the JOYSTICK. The EBL2 appears highlight on the upper right corner of the display. [. . . ] G Before disposing of used lithium battery, insulate by affixing tape to the positive and negative terminals or by other means. In the area where used battery are separated from other waste, dispose of them by following the local regulations. For detail, consult your local distributor, our sales office or your local government. 7. 3 DISPOSAL OF USED MAGNETRON The scanner unit in this radar use a magnetron (NKE-1046). [. . . ]