User manual JUICEMAN JM2000S 10-2009

[. . . ] 28 Attach the spring clips and support bars . 35 2 IMPORTANT SAFETY INSTRUCTIONS Children WARNING- When using your appliance follow basic precautions, including the following: Read all instructions before installation or use to prevent injury and appliance damage. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage. [. . . ] Never mix two types of oil/fat together. Be sure the reservoir has been filled with enough oil, min. Solid fat should be cut into small pieces. If re-using fat which has solidified in the reservoir, make a hole in the fat with a blunt utensil as far down as the heating element. ^ Turn the control knob to 212°F (100°C) and wait until the fat is completely melted. ^ Check the level in the reservoir after the fat has melted. It must be between the minimum and maximum levels as marked on the rear wall of the reservoir. Using the fryer ^ Set the desired frying temperature (see table on next page). Once the temperature control light goes out the oil has reached the set temperature. ^ Place the frying basket containing the food into the hot oil. If the oil froths a lot, briefly remove the basket from the reservoir and slowly lower it again. ^ Remove the basket from the hot oil when the food has finished cooking. oven sprays, stain or rust removers, as these will damage the surface of the appliance. Do not use a stainless steel cleaner in the reservoir. After cleaning use a soft, dry cloth to remove any moisture to prevent the build-up of limescale deposits. 15 Cleaning and care Reservoir ^ Be sure the appliance is cool before draining the reservoir for cleaning (see "After using the fryer"). Stainless steel surfaces The stainless steel surfaces, including the fryer lid, can be cleaned using a non-abrasive stainless steel cleaner (available from Miele). Apply sparingly with even pressure using a soft cloth. Fryer basket Clean the basket after each use using a mild solution of warm water and liquid dish soap. ^ Raise the heating element. ^ Remove any large particles or sediment with a paper towel. ^ Fill the reservoir to the maximum mark with a mild solution of warm water and liquid dish soap. ^ Wash the reservoir using a sponge or a soft non-scratching brush. ^ Drain the water into a suitable container. ^ Once the water has drained clean the drain valve using a bottle brush. [. . . ] The position for attachment of an additional support bar depends on the width of appliance B. 30 Installation Attach the spring clips and support bars Wood or solid surface countertops ^ Place the supplied spring clips a and the support bars b at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1/8" x 1" (3. 5 x 25 mm) screws (supplied). 31 Installation Granite countertop The screws are not needed for granite countertops. ^ Coat the edges of the spring clips a, ^ and the space e between the support bars b and the countertop with silicone (supplied). ^ Position and attach the spring clips a and support bars b with strong, double-sided tape c. 32 Installation Installing the appliance / appliances ^ Feed the power cord down through the cut-out. ^ Place the front edge of the appliance into the cut-out. ^ With a hand on each side of the appliance press down evenly on the edges until it clicks into position. [. . . ]