User manual JUICEMAN JM300 12-2008

[. . . ] They contain important information about the safety, use and maintenance of the appliance. Please read this booklet carefully to prevent accidents and machine damage. Keep these instructions in a safe place for reference, and pass them on to any future user. Technical and electrical safety ~ Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions. Contact Miele's Technical Service Department for examination, repair or adjustment. [. . . ] This is usually solved after 5-10 minutes of ironing. If a new ironing cover is used, wash the cloth at a high temperature (140°F/ 60°C) to achieve an optimal pull-in of the laundry. ^ If you lift the finger guard now, the roller stops rotating and the heater plate rises. This shows that the finger guard is working. ^ Let go of the finger guard and remove your foot from the foot pedal. The heater plate lowers and the roller rotates. 14 Ironing Turning on and off Selecting the ironing temperature The temperature selector is used to set the ironing temperature. The temperature range is marked by dots on the ring around the temperature selector. These correspond with the international fabric care symbols for ironing. Material Minimum Iron Dot Symbol Temperature range cool iron (low temperature) medium hot iron (medium temperature) hot iron (high temperature) 104 - 140 °F (40 - 60 °C) ß ßß ßßß I The rotary iron is turned on and off with the "0-I" button. To turn off ^ Press and release the button. Laundry bar Ironed laundry can be hung over the swing out bar to avoid creasing. , Take care not to press down on the bar when it is swung out, this could cause the rotary iron to tip over. 18 Ironing Ironing tips ­ To avoid creasing stop the roller, pull the item back slightly and smooth out. If necessary, dampen again with a wet cloth or spray bottle. ­ If possible, always use the whole length of the roller, otherwise the roller will lose its elasticity. ^ Start the first run by carefully feeding this end in first on the left side of the roller, taking care not to damage any buttons. ^ It is best to iron the cover in two runs lengthwise. If folds are acceptable ^ Fold the duvet cover lengthwise and iron both sides. 22 Ironing Tips Shirts ^ Remove the feed board to iron shirts. Shoulder yoke ^ Then turn down the collar and press lightly, holding taut. Front sides ^ Arrange the yoke, collar first, on the roller and smooth out. Collar The collar is ironed on both sides using the left hand end of the roller. Stop ironing when the button comes to the heater plate. ^ Lay the button hole front on the left hand end of the roller with the side seam along the edge of the roller. ^ Iron from the button hem up to the armhole. ^ Now move the shirt out and iron past the armhole to the side seam. ^ Iron the button side inside out so the buttons are pressed into the cushioned surface of the roller. 23 Ironing Tips 4. Cuffs and sleeves ^ Start at the side seam. Pull the shirt over the roller as far as the arm hole. [. . . ] Clean with household cleaners or dishwasher detergent. Solution Clean the heater plate with household cleaners or dishwasher detergent. Solution Wash the iron cover with household detergent at 140°F (60°C) or replace with a new one. See "Washing or replacing the ironing cover". [. . . ]