User manual JUICEMAN JM400 8-2009

[. . . ] Please read this booklet carefully to prevent accidents and machine damage. Keep these instructions in a safe place for reference, and pass them on to any future user. ensure that the connection data on the data plate (fusing, voltage and frequency) match the household electrical supply. If in doubt, consult an electrician. ~ The electrical safety of this appliance can only be guaranteed when continuity exists between the appliance and an effective grounding system which complies with local and national safety regulations. [. . . ] Please note: Any unevenness in the ironing cover will smooth itself out after 3 hours of use. When using a new machine, if delicate laundry is not properly pulled into the rotary iron continue ironing. This is usually solved after 5-10 minutes of ironing. If a new ironing cover is used, wash the cloth at a high temperature (140°F/ 60°C) to achieve an optimal pull-in of the laundry. ^ If you lift the finger guard now, the roller stops rotating and the heater plate rises. This shows that the finger guard is working. ^ Let go of the finger guard and remove your foot from the foot pedal. The heater plate lowers and the roller rotates. 13 Ironing Turning on and off Selecting the ironing temperature The temperature selector is used to set the ironing temperature. The temperature range is marked by dots on the ring around the temperature selector. These correspond with the international fabric care symbols for ironing. Material Polyester / artificial silk Silk / Wool Cotton / Linen Dot symbol ß ßß Temperature range cool iron (low temperature) medium hot iron (medium temperature) hot iron (high temperature) The rotary iron is turned on and off with the "I / 0" button. To turn off ^ Press and release the button. The indicator light goes out. ßßß 14 Ironing Selecting the roller speed There are 5 roller speed settings, from low (approximately 6. 5 ft/min. [2 m/min]) to high 15 ft/min. To accentuate embroidery and raised patterns on bedspreads, iron first in one direction and then in the other. ^ Place the tablecloth crossways so that the ends hang over to the left and right. ^ Iron the middle section. Pillow cases ^ Lay the pillowcase on the feeder plate, position under the heater plate and iron in one step. If the open end has buttons, only pass it through the rotary iron if the buttons are heat resistant. ^ Fold in half with unironed edges together and place over the left end of the roller with the ironed middle section hanging over the edge to prevent creasing. Then pass both sides of the non ironed sections through the rotary iron. 20 Ironing Tips Duvet covers To iron without a fold If the duvet cover has buttons at the open end, iron the buttons first. Note: Only pass this end through the rotary iron if the buttons are heat-resistant. ^ Start the first run by carefully feeding this end in first on the left side of the roller, taking care not to damage any buttons. ^ It is best to iron the cover in two runs lengthwise. If folds are acceptable ^ Fold the duvet cover lengthwise and iron both sides. 21 Ironing Tips Shirts ^ Remove the feed board to iron shirts. Front sides ^ Lay the button hole front on the left hand end of the roller with the side seam along the edge of the roller. ^ Arrange the yoke, collar first, on the roller and smooth out. Collar The collar is ironed on both sides using the left hand end of the roller. ^ Iron from the button hem up to the armhole. ^ Now move the shirt out and iron past the armhole to the side seam. ^ Iron the button side inside out so the buttons are pressed into the cushioned surface of the roller. ^ Then turn down the collar and press lightly, holding taut. 22 Ironing Tips 4. [. . . ] The manufacturer cannot be held responsible for unauthorized work. The rotary iron does not turn. Possible fault The rotary iron has no power. Fix Plug the machine in and check if the circuit breaker has tripped. The laundry is not properly or poorly pulled in. This tends to happen when ironing Continue ironing, the issue is usually delicate items with a new machine. [. . . ]