User manual JUKI DX7

[. . . ] Please read this instruction manual before using the machine as it contains important operational and safety information. Keep this manual accessible so that you may refer to it at anytime while operating the machine. When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this sewing machine. The appliance should never be left unattended when plugged in. [. . . ] Turn off the power when setting the clamping plate. It will be easier to sew buttonholes on the thin fabrics and/or near the overlapped sections, if the clamping plate is used. Attach the buttonhole presser foot to the presser foot holder, with the clamping plate together. Place the fabric between the presser foot and the clamping plate. * You can remove the clamping plate by holding A. Turn OFF the power switch before replacing the presser foot. Buttonholes with gimp thread prevent the buttonholes from stretching and can make them more secure. * A buttonhole with gimp thread should be sewn using the double bartack pattern (Pattern No. 1 Pass the needle thread through under the presser foot and then draw the thread to The side of the presser foot. Presser foot, pull the gimp thread under The presser foot and thread it at the hook 3 After threading at the hook, pull the gimp thread back under the presser foot and put it into the notch at the front left side of the presser foot firmly. 4 Bring down the needle to the sewing start point and lower the presser foot. 6 Pull the left gimp thread to take off slack and cut excess gimp thread. When changing the width of the buttonhole When the power is shut down or anoth- Turn to the left Turn to the right When changing the density of the seam Turn to the left Turn to the right Pushing "+" * The width of buttonhole can be changed by ( Turn OFF the power switch before replacing the presser foot. * Turn the "zigzag width" and "stitch length" adjusting dials before sewing when you want to change the buttonhole width and density of the seam. Hole on the presser foot 1 Set the manual buttonhole presser foot (I). 2 Pass the needle thread through the hole of the presser foot and pull it out sideways together. 3 Bring down the needle on the sewing start point and lower the presser foot. * At this time, if the start/stop button is pushed, the machine will stop sewing. And if the start/stop button is pushed again, then the machine will continue to sew the left side of the buttonhole. Push the reverse stitch button when it reaches the necessary length of the left side of the buttonhole. Sew bartack and the right side of the buttonhole, then the machine sews bartack and right side of the buttonhole. 5 Push reverse stitch button when it comes to the sewing start point. [. . . ] 2 Remove the throat plate Remove needle and presser foot and remove the needle plate by using T-shape screwdriver. Remove lint and dirt around the feed dog and bobbin case holder with the cleaning brush. Install the bobbin case holder so that points A and B touch each other. When attaching the throat Pins with holes of throat If sewing difficulties occur, make sure the instructions are correctly followed. [. . . ]