User manual JUKI PIED PRESSEUR

[. . . ] Then place the tape Roller guide under the presser foot and bring it toward the rear side of the presser foot. Tighten the presser foot adjustment screw a little more. an elastic tape as wide as 12 mm can be used. [. . . ] How to use the beading presser foot Gebrauch de Zierbiesendrückerfußes Comment utiliser le pied presseur à emperler Modo de usar el prensatelas der perlado Come usare il piedino per bordatura perlinata Raise the beading presser foot, put pearl beads under the presser foot so that they are fed from the rear of the presser foot. Feed regulating knob Lower knife adjusting knob Overedging width change-over knob (3 to 4) Adjust so that pearl beads do not come in contact with the upper knife. (Differential feed regulating knob) (2) Adjusting the thread tension regulating dial Needle thread tension Upper looper thread tension Lower looper thread tension (3) Thread to be used Upper looper thread Lower looper thread Needle thread Turn the handwheel by hand to sew two to three stitches to make threads entangle pearl beads. Then, press the material until it reaches the knife. Division on scale 2 to 3 3 to 5 5 to 7 * Pearl beads at the end are likely to move out of position. So, do not depress the controller pedal, raise the beading presser foot and remove the pearl beads. * After the completion of sewing, draw the material through your hands to make the looper thread enter between pearl beads. How to use the piping presser foot Gebrauch des Paspeldrückerfußes Comment utiliser le pied presseur à ganser Modo de usar el prensatelas de ribetes de vivos Come usare il piedino per profilare * The piping presser foot cannot be used with a 1-needle, 2-thread machine. * The piping presser foot can be used with a 1-needle, 3-thread machine. (1) Adjusting the operating knobs Division on scale Feed regulating knob Lower knife adjusting knob Overedging width change-over knob (Differential feed regulating knob) 2 to 2. Cloth (right side) Piping tape (Position so that its thicker side comes to the left-hand side. When performing sewing with three threads, use the left needle. Size of piping tape and material thickness that can be used How to use the blind hem/universal guide foot Verwendung des Blindsaum-/Universalführungsfußes Sewing and finishing Place the fold of the fabric against the left side of the guide allowing the seam allowance of the hem to lay under the guide. the needle thread should barely be visible on the right side of the garment. [. . . ] Secure your end chain in your favorite method. When serging pearls, another way to end would be to measure and cut the beads 25mm (1") beyond the last bead to be serged. Using pliers, crush the excess beads leaving only the string. [. . . ]