User manual JUNIPER NETWORKS NETWORK AND SECURITY MANAGER NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3

[. . . ] NSM Configuration Guide for EX Series Devices Release Published: 2010-11-15 Part Number: 530-028689-01, Revision 3 Copyright © 2010, Juniper Networks, Inc. Juniper Networks, Inc. 1194 North Mathilda Avenue Sunnyvale, California 94089 USA 408-745-2000 www. juniper. net This product includes the Envoy SNMP Engine, developed by Epilogue Technology, an Integrated Systems Company. Copyright © 1986-1997, Epilogue Technology Corporation. This program and its documentation were developed at private expense, and no part of them is in the public domain. [. . . ] In the configuration tree, expand Routing Options. Enter the parameters as specified in Table 44 on page 71. Click one: · · · OK--To save the changes. Apply--To apply the routing option settings. NOTE: After you make changes to a device configuration, you must push that updated device configuration to the physical security device for those changes to take effect. You can update multiple devices at one time. See the Updating Devices section in the Network and Security Manager Administration Guide for more information. Table 44: Source Routing Fields Option Comment Function Specifies the comment for the source routing configuration. Your Action Enter the comment. Copyright © 2010, Juniper Networks, Inc. 71 Table 44: Source Routing Fields (continued) Option Ip Function Specifies the IPv4/IPv6 addressing family for source routing. Your Action Select the check box. Configuring Static Routes (NSM Procedure) You can configure static routes for a routing table group. A router uses static routes in the following scenarios: · When it does not have a route to a destination that has a better (lower) preference value. When it cannot determine the route to a destination. When it is forwarding unroutable packets. · · A static route is installed in the routing table only when the route is active; that is, the list of next-hop routers configured for that route contains at least one next hop on an operational interface. To configure static routes for a routing table group in NSM: 1. In the navigation tree, select Device Manager > Devices. 2. In the Devices list, double-click the device to select it. In the configuration tree, expand Routing Options. Add or modify the parameters as specified in Table 45 on page 73. Click one: · · · OK--To save the changes. Apply--To apply the routing option settings. NOTE: After you make changes to a device configuration, you must push that updated device configuration to the physical security device for those changes to take effect. You can update multiple devices at one time. See the Updating Devices section in the Network and Security Manager Administration Guide for more information. 72 Copyright © 2010, Juniper Networks, Inc. Chapter 7: Configuring Routing Options Table 45: Static Fields Option Comment Function Specifies the comment for the static route. Specifies the routing table group name for which the static route is configured. Enables you to configure the global static route options. These options only set the global defaults and apply to all the configured static routes. Your Action Enter the comment. Rib Group Enter the name. Defaults 1. Expand the Static tree and select Defaults. 2. Enter the default route to the destination address. Expand the Static tree and select Route. Route Enables you to configure the individual static routes options. [. . . ] See Connecting a Virtual Chassis Cable to an EX4200 Switch. NOTE: Arrange the switches in sequence, either from top to bottom or from bottom to top (0­9). Copyright © 2010, Juniper Networks, Inc. 149 4. Power on only the switch that you plan to use as the master switch (SWA-0). Do not power on the other switches at this time. 5. Run the EZ Setup program on SWA-0, specifying the identification parameters. [. . . ]