User manual JUNO EMZU 1480 WS ELT EBH

[. . . ] We promise that it'll make your life a little easier. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. OFF: Keep pressed the button (B) until the pilot light (A) and the temperature indicator switches off. The temperature can be adjusted between +2°C and +8°C. The indicator displays the newly selected temperature for a few seconds and then shows again the inside compartment temperature. The newly selected temperature must be reached after 24 hours. During the stability period and when first starting the appliance the temperature displayed does not correspond to the setting temperature. During this time it is possible that the temperature displayed is lower than the setting temperature. Temperature indicator During normal functioning the indicator shows the temperature inside the fridge. During normal functioning the indicator shows the warmest temperature inside the freezer. Differences up to 5°C inside the compartment are quite normal. After the temperature has returned to normal, the warning light (O) will continue to flash, although the buzzer has stopped. when the alarm button (P) is pressed , the warmest temperature reached in the compartment flashes on the indicator (K). If the power has been off for a long time, frozen food should be consumed as quickly as possible, or cooked and then re-frozen. This temperature will be reached in a few hours. As soon as the appliance is switched on the temperature indicator (K) shows the current temperature inside the freezer, the alarm reset light (O) flashes and a buzzer sounds. The buzzer stops and the alarm light (O) continues to flash until the setting temperature is reached. By the switching off of the freezer compartment it is switched off also the refrigerator compartment. To freeze fresh foods, the "Super frost" function must be activated. The relevant pilot light (M) switches on The function can be deactivated at any time, by pressing the button (N), otherwise it automatically switches off. [. . . ] This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation When defrosting is completed, dry the interior thoroughly and refit the plug; keep the scraper for future use; 4. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. [. . . ]